813412

Gazco Studio Freestanding Balanced Flue Manual

38
Zoom out
Zoom in
Previous page
1/52
Next page
38
Servicing Instructions - Replacing Parts
1. General
1.1 All main components can be replaced without removing the
appliance from its installation.
IT IS ESSENTIAL THAT THE GAS SUPPLY TO THE
APPLIANCE IS TURNED OFF AT THE ISOLATION
DEVICE BEFORE PROCEEDING FURTHER.
1.2 DISCONNECT BATTERIES BEFORE SERVICING THE
APPLIANCE.
Removal of Flue
1.3 If, for any reason, the flue has to be removed from the
appliance, the seal must be replaced in the inner
spigot.
1.4 Access to the controls is restricted and the whole control
assembly must be removed as one unit (see Section 7
below).
2. Decorative Frame
2.1 Remove the decorative front by lifting to disengage the
fixing hooks from the locating slots, see Diagram 1.
1
NOTE: THE STEEL FRAME IS HEAVY.
TAKE CARE WHEN LIFTING.
3. Window Frame Assembly
3.1 To open the glass door use the hexagon key provided.
3.2 Release the window locks by moving them from shut to
open towards the outer edges, see Diagram 2.
2
3.3 To completely remove the glass front:
3.4 Support the frame and lower it gently forward down to its
natural stop position, see Diagram 3.
DO NOT EXERT PRESSURE ON THE DOOR ONCE
THERE IS RESISTANCE.
3
3.5 Remove the securing spring clip from the bottom-right of the
window frame, see Diagram 4.
4
3.6 With the window frame in an upright position slide the frame
to the left so that it comes off the left hinge pin, see Diagram
5 (1).
3.7 Still keeping the frame upright drop the left side down and
forward slightly, see Diagram 5 (2).
5
1
2
3.8 Slide the frame to the right so it comes off the right hinge
pin. The window frame should now be free.
3.9 Refit the Window Frame Assembly in reverse order.
When closing the door ensure the door catches are fully
engaged.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED WITHOUT THE CATCHES
HOLDING THE DOOR IN PLACE.
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gazco Studio Freestanding Balanced Flue at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gazco Studio Freestanding Balanced Flue in the language / languages: English as an attachment in your email.

The manual is 8.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info