813412

Gazco Studio Freestanding Balanced Flue Manual

15
Zoom out
Zoom in
Previous page
1/52
Next page
15
5. Ventilation
5.1 This appliance requires no additional ventilation.
6. Appliance Location
6.1 This appliance has been designed to stand on a designated
bench or plinth.
6.2 For practical reasons, the floor should be flat and solid to
allow the appliance to be levelled and secured in place.
6.3 This appliance may be situated anywhere in the room, but
due consideration should be taken to ensure that it is sited
within the constraints of the allowable flue configuration.
6.4 If the appliance is to be sited against a combustible wall, a
clearance of 50mm should be allowed between the wall and
the rear of the appliance.
6.5 This appliance must not be installed in a room that contains
a bath or shower.
6.6 Installations on a Bench or Plinth do not need a non-
combustible floor but the appliance must not be fitted
on a carpet. Use a solid floor.
6.7 Installations on a Bench or Plinth do not require fixing to the
floor.
6.8 To secure the appliance to the Bench or Plinth follow the
instructions on Page 17.
6.9 This appliance can be installed with an up and out flue
(vertical wall - horizontal flue) or with a vertical flue with roof
termination (see Flue Options, Section 2 Site
Requirements).
Minimum Clearance
6.10 The appliance is not suitable for installation against a
combustible wall. All combustible materials must be
removed from behind the appliance.
6.11 Ensure that all minimum clearances to combustible
materials are complied with, see Diagrams 2 & 3.
The specified clearances provide the minimum distance to
combustible materials. If the appliance is intended to be
installed into a non-combustible opening the clearance to the
sides and above the appliance can be reduced. However, it
is recommended that the specified clearances are
maintained irrespective of the materials used in the
construction of the opening to allow adequate air flow and
access to controls.
100
225
100
2
50
100
3
Installation Instructions
Site Requirements
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gazco Studio Freestanding Balanced Flue at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gazco Studio Freestanding Balanced Flue in the language / languages: English as an attachment in your email.

The manual is 8.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info