813400

Gazco Steel Manhattan Coal Conventional Manual

14
Zoom out
Zoom in
Previous page
1/28
Next page
14
3. Installation of the Appliance
3.1 Decide whether to use top or rear flue exit.
The appliance is factory built for rear flue exit but it can be
changed to top exit by swapping the flue spigot and blanking
plate located on the appliance.
When installing with a top flue please note the flue pipe
fits through a hole in the top grill, the dimensions are
for floor fixing a top flue installation with clearance for
side panels.
3.2 Position the engine assembly in its intended location and
mark the position of the two floor fixing holes at the base of
each side of the subframe, minimum fixing dimensions to a
rear wall are shown in Diagram 1.
158mm
1
3.3 Remove the assembly and drill the two holes using a No. 12
masonry bit.
3.4 Push the rawl plugs into the holes, and place the engine
assembly in position.
3.5 Secure to the floor using the screws provided, see Diagram 1.
3.6 Having run the gas supply to the appliance PURGE THE
SUPPLY PIPE.
This is essential to expel any debris that can block the gas
controls.
3.7 Connect the gas supply to the 8mm-compression elbow at
the right-hand rear corner of the appliance, ensuring that the
pipe position does not interfere with the location of the outer
steel casing, see Diagram 2.
2
Installation Instructions
3.8 Open the second carton, and carefully remove the steel
outer casing components.
3.9 Remove the protective plastic coating from the 2 side
assemblies and lower them onto the engine assembly until
the lugs locate as shown, check that the feet are touching
the hearth, see Diagram 3.
3
3.10 Secure the upper front panel using the 4 nuts and bolts
provided, see Diagram 4.
4
3.11 Locate the lower panels onto the lugs as shown, see
Diagram 5.
5
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gazco Steel Manhattan Coal Conventional at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gazco Steel Manhattan Coal Conventional in the language / languages: English as an attachment in your email.

The manual is 2.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info