22
SERVICING INSTRUCTIONS
REPLACING PARTS
1. GENERAL
1.1 All principal components can be replaced without removing
the stove from its installation, although it is essential that the
gas supply to the appliance is turned off at the isolation
device before proceeding further.
1.2 If, for any reason, the flue has to be removed from the stove,
the seals must be replaced.
2. MAIN BURNER
2.1 Turn the gas supply off at the isolation device, remove the
door and place to one side, carefully remove the ceramic
fuel bed components.
2.2 Remove the three securing screws, two at the rear and one
at the front left hand side. See diagram 1. Raise the left hand
side of the burner to clear the bracket, draw the left hand
side forward. The burner venturi is engaged over the
injector. When removing the burner be sure to clear the
injector, this will release the right hand side of the burner.
Take care when removing the burner so as not to damage
the pilot burner.
2.3 To replace the burner, engage the venturi over the injector
ensuring the burner sits on top of the fixing bracket. Push
the burner to the right and whilst holding, insert the three
fixing screws.
NOTE: BEFORE REPLACING THE BURNER, ENSURE THE
SILICONE SEAL AROUND THE INJECTOR IS INTACT AND
CHECK THAT VENTURI COVER IS ATTACHED.
AR1605
1
3. PILOT UNIT
The pilot assembly consists of five components, which can
be individually changed, these are:
1) Pilot burner bracket
2) Pilot injector
3) Electrode
4) Thermocouple
5) Gasket.
3.1 Turn the gas supply off at the isolation device, remove the
door and place to one side, carefully remove the ceramic
fuel bed components
3.2 Refer to Section 2 to remove the main burner. Remove the
thermocouple baffle taking note of how it is positioned.
Refer to Diagram 2
3.3 Remove the two fixing screws from the pilot bracket, see
diagram 3. Gently draw the assemble away from the firebox
to give access to the nuts and ignition lead.
NOTE: TAKE CARE NOT TO DAMAGE THE GASKET.
AR1609
2
AR0614
3
