714689
144
Zoom out
Zoom in
Previous page
1/148
Next page
EN
144
IMPORTANT - You cannot terminate the descaling program prematurely. Leave
the program run until the complete cycle is finished and the appliance switches
off automatically. You need a large vessel (for at least 2.5 litres) fitting under the
group head. The descaling cycle will require up to 45 minutes.
1. Switch off the appliance via the power button and unplug. Then clean the appli-
ance (see above).
2. Prepare approx. 2500ml descaling solution according to the instructions on the
pack.
IMPORTANT - It is important to fill the water tank with the correct amount of des-
caling solution. Otherwise, the machine would completely empty the water tank.
This could damage the pump!
3. Pull the water tank upwards and out of the appliance and empty the water tank.
Remove the water filter and place the water filter into a bowl with clear tap
water.
4. Rinse the water tank with clear tap water. Then fill the descaling solution into the
water tank. Wipe dry the exterior of the water tank and re-install the water tank
at the back of the appliance (see: ‘Operation / Filling the Water Tank’).
5. Ensure that the drip tray is empty and inserted correctly. Place a heat-resistant
vessel of sufficient size (at least 2500ml) under the group head and direct the
steam wand into the vessel.
6. Plug in the power plug. For starting the de-scaling program press the 1 cup but-
ton, 2 cups button, and power button simultaneously for approx. 3 seconds.
The descaler solution comes out from the steam wand and the group head. Both
espresso buttons are flashing.
NOTE
The descaling program removes lime deposits from the water system by automati-
cally performing a series of rinses and pauses until the water tank is almost empty.
At the end of the descaling process the espresso buttons get dark, but the desca-
ling indicator flashes. Remove the water tank. Empty the water tank completely
and rinse thoroughly with clear tap water. Thereafter, fill the water tank again with
clear tap water. Ensure that the exterior of the water tank is dry and replace the
water tank at the rear of the appliance.
7. Remove and empty the vessel holding the descaling solution. Then replace the
vessel under the group head. Direct the steam wand into the vessel.
8. Hold the power button and both espresso buttons (1 cup button and 2 cups
144


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gastroback 42619 - Design Espresso Advanced Barista at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gastroback 42619 - Design Espresso Advanced Barista in the language / languages: English, German as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info