512654
16
Zoom out
Zoom in
Previous page
1/17
Next page
Waste disposal
The appliance has to be deposed by the definition of the regional waste disposal of
electrical scrap.
If necessary get information of the regional waste management enterprise.
Warranty
We guarantee that all our products are free of defects at the time of purchase.
Any demonstrable manufacturing or material defects will be to the exclusion of any further
claim and within 2 years after purchasing the appliance free of charge repaired or substituted.
There is no Warranty claim of the purchaser if the damage or defect of the appliance is
caused by inappropriate treatment, over loading or installation mistakes.
The Warranty claim expires if there is any technical interference of a third party without
an written agreement.
The purchaser has to present the sales slip in assertion-of-claims and has to bear all charges
of costs and risk of the transport.
The warranty becomes invalid and GASTROBACK does not assume liability if:
1. The user did not follow the instructions or the user did not use the appliance as stated and
only for thus use (improper use, misusage).
2. The appliance was connected to a power supply with improper current.
3. The mincer got opened by an unauthorised person.
4. Other then original spare-parts got used.
5. The appliance was in commercial use. Used up parts from commercial use are no
warranty claim.
The mincer is intended for use in the household only!
The mincer blocks up permanently
while operating.
The mincer head moves or loosened while
operating.
The mince leaks out at the side of the
closing ring.
Clear a blocking
If the mincer head is blocked no mince comes out of the mincer while operating or the motor stops
moving automatically because of the overload protection.
ATTENTION: If a blocking occurs turn OFF the appliance immediately. Clear the problem
before turning on the motor again.
1. Turn the appliance OFF and then take the feedstick out of the feed funnel.
2. If the motor stopped running because the overload protection turned itself on you have to
turn the appliance OFF to undo the overload protection.
3. Turn the motor ON and OFF by turns to loosen the blocking.
ATTENTION: If the motor still does not start running turn the appliance OFF, pull the plug
and clean the appliance.
To ensure that the mincer does not seize, never operate it under
excessive pressure. Operate in a slow and constant pace. Do not
try to rush the procedure by pushing down the meat with force.
For mincing hard ingredients really fine start with the mincer plate
with the bigger holes. Mincing the second time use the finer mincer
plate.
The screw plug loosened. Turn the appliance OFF immediately. Press the
mincer head with one hand against the motorblock using the other
hand to tighten the screw plug turning it clockwise.
The closing ring is not screwed on tight enough. Turn the appliance OFF
immediately and then pull the plug. Tighten the closing ring but do not
overwind the winding. If the problem still occurs disassemble and clean
the appliance.
Possible problem Easy solution
3130
41401_Manual_Neu.qxp 01.10.2008 15:40 Seite 30
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gastroback 41401 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gastroback 41401 in the language / languages: German as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gastroback 41401

Gastroback 41401 Manual - German - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info