714616

Gastroback 41150 Manual

57
Zoom out
Zoom in
Previous page
1/64
Next page
EN
57
Problem Possible Reasons The Easy Solution
The fruit half turns with
the juicing cone.
Hard bulges at the tip ends
of the fruit halves cause
poor contact of the fruit
dome and the fruit shell.
Cut the bulges at the tip ends of the fruit flat. Then try
again.
The fruit half is too large. The fruit halves may not be larger than the juicing cone
(max. 7 cm in height). When the fruit is pressed down via
the fruit dome, at least 1 cm (1/2 inch) of free space must
be left at the bottom of the juicing cone. Cut off an appro-
priate slice at the open end of the fruit half for getting good
contact to the juicing cone. Note: The fruit slices may be
used for decorating the glasses, when serving the juice.
The interior of the fruit
dome is obstructed by resi-
dues of the fruit shells.
Unplug the appliance and remove the fruit dome (see:
‘Operation / Disassembling the Appliance’). Then clean
the fruit dome. Thereafter, try again.
You need to press a little
harder on the press arm.
Increase the pressure on the press arm just until the fruit
half does not turn with the juicing cone.
There is a lot of white
and bitter inner shell in
the juice OR the pulp is
very wet.
You apply too much pres-
sure to the press arm.
When pressing too hard, the white inner shell of the fruit
may be scratched off and get into the juice—especially
when using the coarse filter basket. Decrease your juicing
speed by reducing the pressure on the press arm. Push
down the press arm just until the motor starts. This way,
you get the maximum amount of juice.
Not enough juice. The fruit is somewhat dry
already.
Always use fresh fruit for juicing. Especially small citrus
fruit may get dry after some days of storage.
The fruit half is too large. The fruit halves may not be larger than the juicing cone
(max. 7 cm in height). When the fruit is pressed down
via the fruit dome, at least 1 cm (1/2 inch) of free
space must be left at the bottom of the juicing cone. Cut
off an appropriate slice at the open end of the fruit half
for getting good contact to the juicing cone.
You apply too much pres-
sure to the press arm.
Decrease your juicing speed by reducing the pressure on the
press arm. Push down the press arm just until the motor
starts. This way, you get the maximum amount of juice.
The juice level rises in the
filter basket. The juice
does not flow out into
your juice vessel.
Too much pulp in the filter
basket. The filter basket is
clogged.
Unplug the appliance and empty the filter basket. If
required, rinse stubborn fibres of the pulp from the strai-
ner (see: ‘Operation / Emptying the Filter Basket and
Removing Obstacles’).
… 57 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gastroback 41150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gastroback 41150 in the language / languages: English, German as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info