Manual Gastroback 40977 (page 62 of 65) (English, German)

714637

Zoom out

Zoom in

1/65

EN EN

122 123

PREPARATION FOR CLEANING

1. Press the control dial until only dashes are shown on the display areas (see:

‘After Usage’). Unplug the machine.

2. Remove the removable parts (see: ‘After Usage’).

CLEANING THE HOUSING

IMPORTANT - For getting a stable stand on the work surface, the suction cups

at the feet of the machine must be clean. Usually, you do not need to clean the

suction cups. However, when flour or sticky liquids have been on the work sur-

face, the suction cups may get polluted, causing the machine to excessively move

around during operation. In this case, you should remove any pollution from the

suction cups. For this, always use only soft clothes. Do not scratch or scrape on

the suction cups.

3. Hold the unlock button at the joint of the mixing arm pressed, while moving the

mixing arm to the upper position. Ensure that the mixing arm engaged securely

in this position.

4. If required, remove any residues and splashes from the drive shafts of the mixing

drive and from the bottom of the mixing arm with a soft, slightly damp cloth. Then

press the unlock button and slowly lower the mixing arm to the operating position.

5. Wipe the housing of the mixer. Avoid dripping any liquids into the joint of the

mixing arm. Wipe any food particles from the power cord.

6. Carefully wipe dry the housing after cleaning. If required, carefully clean the

suction cups at the feet of the base plate: For this, the mixing arm must be enga-

ged in the lower operating position. Lay the machine (without mixing tools and

mixing bowl) carefully onto its left side. Use a SOFT, damp cloth for cleaning.

After removing any residues, wipe with clear water and thoroughly dry the suc-

tion cups via a soft cloth.

CLEANING THE TOOLS AND ACCESSORIES

IMPORTANT - Do not clean the mincing discs in the automatic dishwasher. We

recommend to clean the steel mincing discs regularly, even when they have not

been used. This will avoid a rancid or resinous taste and smell. Always rub the

mincing discs with some cooking oil after cleaning. If you wish to use an auto-

matic dishwasher for cleaning, carefully observe the instructions given in the

following section (‘Cleaning in the Automatic Dishwasher’).

Problem Reason Easy solution

There are residues of food

or liquids within the min-

cer coupling of the mixing

arm.

The processed food has

been too runny and/or

too juicy.

Only process types of food via the mincer, which do not

give off much juices when being pressed. The mincer is

NOT suited for juicing fruit and vegetables. Additionally,

it is not suited for processing any type of runny food. Do

not pour any liquids into the feed chute, while the mincer

is assembled to the mixing arm of the machine.

The screw ring got loose. When assembling the mincer, turn the screw ring some-

what tighter. However, do not turn it with violence. Ensu-

re that the mincer is assembled completely and correctly

(see: ‘Using the Mincer’).

The mincer is not assem-

bled correctly.

Ensure to assemble the mincer completely and correctly accor-

ding to the instructions, before starting operation (see: ‘Using

the Mincer’).

CARE AND CLEANING

WARNING – Always ensure that the machine is out of reach of young

children! Do not hold your hands or any foreign objects (e.g. cooking utensils,

brushes, clothes) onto the moving parts (mixing drive, mixing tools, worm shaft and

cross blade of the mincer), while the machine is connected to the power supply.

Always switch off the motor (press the control dial) and unplug from the mains

power supply, before moving or cleaning the machine. Do not touch the machine

with wet hands or when the machine is wet (e.g. by condensate), while the machi-

ne is connected to the power supply. Do not place the machine on a power cord

or on wet surfaces. Do not immerse the machine or power cord into water or any

other liquid. Do not spill any liquids onto the machine.

CAUTION – Do not use any hard or sharp-edged objects, corrosive chemicals,

disinfectants, abrasive cleaners, or metal scouring pads for cleaning the machine or

any part of it. Do not poke with any foreign objects in the mincer coupling, mixing

drive, or in the joint of the mixing arm. Do not use violence. Do not place the machi-

ne or the power cord in an automatic dishwasher. Additionally, some accessori-

es and tools are NOT suited for cleaning via hot water and/or in an automatic

dishwasher (see below: ‘Cleaning in an Automatic Dishwasher’).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gastroback 40977 in the language / languages: English, German as an attachment in your email.

The manual is 1,22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gastroback 40977 Manual

Product: