801390
7
Zoom out
Zoom in
Previous page
1/34
Next page
Adjusting the Trainer Geometry
Before you assemble the Tacx NEO Bike Plus trainer, consider that the saddle and handlebar have set screws
installed from the factory that can be adjusted and tightened using a hex key. To install the 4 handles as shown
in this manual, you must remove the 4 set screws using a hex key.
NOTE: If multiple riders will use the trainer, Tacx recommends installing the handles for easy adjustments. The
handles are packaged in the assembly kit with the screws and washers. If you are the only rider that will use the
trainer and you do not make geometry or posture adjustments, you can use the set screws and a hex key.
Get off the trainer before adjusting the saddle or handlebar.
Remove your tablet before adjusting the handlebar height, reach, or angle.
Match the geometry of the trainer to your road bike (Tips for Proper Bike Fit, page27).
If you adjust your saddle more than 1 cm, check the saddle height and the handlebar reach again.
Do not exceed the maximum range of the saddle or handlebar.
If you change your pedals or saddle, check the geometry of the trainer again.
After you tighten each handle bolt, you should align the handle to be parallel to the frame or rail. Pull out and
twist the handle.
Before Assembly 3
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Tacx Neo Bike Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Tacx Neo Bike Plus in the language / languages: English as an attachment in your email.

The manual is 8.6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin Tacx Neo Bike Plus

Garmin Tacx Neo Bike Plus User Manual - German - 34 pages

Garmin Tacx Neo Bike Plus User Manual - Dutch - 34 pages

Garmin Tacx Neo Bike Plus User Manual - French - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info