801381
21
Zoom out
Zoom in
Previous page
1/26
Next page
3Set the battery cover and battery aside.
4Use a small Phillips screwdriver (PH 00) to remove the two screws from inside the battery carriage .
5Remove the battery carriage.
6While securely holding the wrench flats with a pedal wrench, use a 12 mm socket wrench to unscrew the
spindle nut .
NOTE: The right pedal has a black spindle nut and a reverse thread. The left pedal has a silver spindle nut
and a standard thread. The left spindle has a line on the wrench flats.
7Slide the spindle out of the pedal body.
8Remove all old grease from the spindle.
9Apply a layer of bike grease to the spindle.
10 Insert the spindle into the new pedal body.
The new pedal body has factory-installed dust seals. The outer dust seal should be flush with the top of the
cartridge.
11 Replace the spindle nut.
12 While securely holding the wrench flats with a pedal wrench, use a 12 mm socket wrench to torque the
spindle nut to 7 lbf-ft. (10 N-m).
WARNING
To ensure that the spindle nut stays in place, you must tighten it to the recommended torque specification.
Failure to properly tighten the nut could cause the pedal to fall off during a ride, which could result in property
damage or serious bodily injury or death.
13 Replace the battery carriage and two screws.
14 Replace the battery and battery cover, and hand tighten it.
NOTE: Do not damage or lose the O-ring gasket.
15 Use a 4 mm hex key to tighten the battery cover to 3.6 lbf-ft. (5 N-m).
The LED displays one short green flash followed by one long red flash.
16 Install the pedals on your bike (Installing the Pedals, page2).
Appendix 17
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin RS 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin RS 200 in the language / languages: English as an attachment in your email.

The manual is 3.2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin RS 200

Garmin RS 200 User Manual - German - 28 pages

Garmin RS 200 User Manual - Dutch - 28 pages

Garmin RS 200 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info