801309
6
Zoom out
Zoom in
Previous page
1/22
Next page
6If you are installing the transducer on a trolling motor shaft equal to or less than 25mm (1in.) in diameter,
wrap the rubber liner around the shaft in the location where you want to install the mount.
NOTE: The rubber liner is not needed when installing the transducer on a trolling motor with a shaft diameter
that is larger than 25mm (1in.), such as the Garmin Force® trolling motor.
7Orient the mounting bracket on the shaft so the arrows on the inside of the front half of the bracket point
upward.
The bracket should be aligned so the center screw hole faces the front of the trolling motor.
8Place the bracket around the rubber liner on the trolling motor shaft, insert the screws into the mount
bracket, and secure them using the M6 hex wrench.
9(Optional) Transition the trolling motor from the deployed to the stowed position and back again to test the
location of the mounting bracket, and make any adjustments as needed.
10 Hold the extension arm so the 90-degree angle points downward, and attach the shorter length of the
extension arm to the mounting bracket using the shorter knob .
11 Place the transducer below the longer length of the extension arm, and attach it using the longer knob .
NOTE: You can attach the extension arm to the mounting bracket and attach the transducer to the extension
arm using the included low-profile hardware instead of the knobs if you do not plan to switch transducer
modes frequently during use (Installing the Transducer Using Low Profile Mounting Hardware, page14).
12 Secure the transducer cable to the motor shaft or other secure location.
13 Route the transducer cable to the installation location of the sonar module, while taking these precautions.
You must route the cable so it does not come in contact with the propeller when the trolling motor is
operating.
You should not route the cable close to electrical wires or other sources of electrical interference.
You must route the cable so it is not pinched when the trolling motor is deployed or stowed.
NOTE: If necessary, for extra cable length, you can connect an optional extension cable, available at buy
.garmin.com or from your Garmin dealer.
14 Position the transducer at your desired angle (Viewing Modes, page7).
6
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin LIVESCOPE XR LVS62 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin LIVESCOPE XR LVS62 in the language / languages: English as an attachment in your email.

The manual is 4.09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin LIVESCOPE XR LVS62

Garmin LIVESCOPE XR LVS62 Installation Guide - German - 22 pages

Garmin LIVESCOPE XR LVS62 Installation Guide - Dutch - 22 pages

Garmin LIVESCOPE XR LVS62 Installation Guide - French - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info