522257
4
Zoom out
Zoom in
Previous page
1/12
Next page
Connection Considerations
NOTICE
A blue rubber seal is included for each DVI port on the device.
This seal must be installed between each DVI port and DVI-
cable connector to avoid damage to the connectors.
When connecting the GPSMAP 8500 to power, to a GMM, and
to other Garmin devices, observe the following considerations.
Although it is recommended to use the Garmin provided DVI-
D cables, high-quality third-party DVI-D cables may be used.
You should test the DVI-D cable by connecting the devices
before routing the cable.
The GPSMAP 8500 should be connected to the same power
source as a connected GMM and GRID. If this is not
possible, the devices must be connected to the same
ground.
You should make sure that the power and ground
connections to the battery are secured and will not become
loose.
The GPSMAP 8500 can be controlled by touchscreen using
one of the possible two connected GMM devices.
The GMM used to control the GPSMAP 8500 must be
connected to both the GARMIN MONITOR and MAIN
DVI-I VIDEO ports on the GPSMAP 8500 using a Garmin
Marine Network cable and a DVI-D cable.
A GMM or other display connected to the MIRROR DVI-I
VIDEO OUT port will show the same image displayed on
the main GMM, but will not allow touchscreen control.
Garmin Marine Network devices can be connected to any of
the NETWORK ports, except for the GARMIN MONITOR
port, which is reserved for use with the primary GMM.
For easer cable routing, the power, NMEA
®
0183, and
Garmin Marine Network cables are packaged without the
locking rings installed. You should route the cables before
you install the locking rings.
After connecting a locking ring to a cable, make sure the ring
is securely connected and the o-ring is in place so the power
or data connection remains secure.
Station Connection Considerations
This device can be set up in conjunction with other compatible
Garmin devices to work together as a station. When planning
stations on your boat, observe these considerations.
Devices prior to the GPSMAP 8000 series and GPSMAP
8500 cannot be used in a station.
Although it is not necessary, it is recommended that you
install all of the devices you plan to use in one station near
each other.
No special connections are necessary to create a station, as
long as all of the devices are connected to the Garmin
Marine Network (page 5).
Stations are created and modified using the device software.
See the owner's manual provided with the device for more
information.
Connecting to Power
WARNING
When connecting the power cable, do not remove the in-line
fuse holder. To prevent the possibility of injury or product
damage caused by fire or overheating, the appropriate fuse
must be in place as indicated in the product specifications. In
addition, connecting the power cable without the appropriate
fuse in place will void the product warranty.
1
Route the power cable to the power source and to the
device.
2
Connect the red wire to the positive (+) battery terminal, and
connect the black wire to the negative (-) battery terminal.
3
Install the locking ring and o-ring on the end of the power
cable.
4
Connect the power cable to the device by turning the locking
ring clockwise.
Power Cable Extensions
If necessary, the power cable can be extended using the
appropriate wire gauge for the length of the extension.
Item Description
À
Fuse
Á
Battery
Â
6 ft. (1.8 m) no extension
Item Description
À
Splice
Á
12 AWG (3.31 mm²) extension wire, up to 15 ft. (4.6 m)
10 AWG (5.26 mm²) extension wire, up to 23 ft. (11 m)
8 AWG (8.36 mm²) extension wire, up to 36 ft. (11 m)
Â
Fuse
Ã
8 in. (20.3 cm)
Ä
Battery
Å
8 in. (20.3 cm)
Æ
36 ft. (11 m) maximum extension
Additional Grounding Considerations
This device should not need any additional chassis grounding in
most installation situations. If interference is experienced, the
included grounding screw
À
can be used to connect the device
to the water ground of the boat to help avoid the interference.
Connecting a GMM to the GPSMAP 8500
One GMM can connect to the GPSMAP 8500 with touchscreen
control, and an additional GMM or third-party display can be
connected to the GPSMAP 8500 to mirror the primary display.
NOTE: These instructions only cover the video and data
connections of the GMM and third-party display. Consult the
instructions provided with your GMM and third-party display for
information regarding power connections.
1
Route a Garmin Marine Network cable and a DVI-D cable to
the primary GMM and the GPSMAP 8500.
2
Route a DVI-D cable to an additional GMM or an appropriate
cable to a third-party display (optional).
4
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GPSMAP 8530 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GPSMAP 8530 in the language / languages: English as an attachment in your email.

The manual is 1,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin GPSMAP 8530

Garmin GPSMAP 8530 User Manual - English - 62 pages

Garmin GPSMAP 8530 User Manual - German - 14 pages

Garmin GPSMAP 8530 User Manual - German - 42 pages

Garmin GPSMAP 8530 Installation Guide - Dutch - 14 pages

Garmin GPSMAP 8530 User Manual - Dutch - 40 pages

Garmin GPSMAP 8530 Installation Guide - French - 14 pages

Garmin GPSMAP 8530 User Manual - French - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info