583758
3
Zoom out
Zoom in
Previous page
1/106
Next page
GPSMAP 2106/2110 Owner’s Manual i
INTRODUCTION > ABOUT THIS MANUAL AND MANUAL CONVENTIONS
INTRODUCTION
Thank you for choosing the Garmin
®
GPSMAP
®
2106/2110. The
GPSMAP 2106/2110 uses the proven performance of Garmin GPS and
full-featured mapping to create an unsurpassed marine Multi-Function Display
(MFD). Take a moment now to compare the contents of this package with the
packing list on the outside of the box. If any pieces are missing, contact your
Garmin dealer immediately.
Installing Your GPSMAP 2106/2110
To install the GPSMAP 2106/2110, refer to the GPSMAP 2106/2110 & GPS 17
Installation Instructions. To complete the installation, you need the appropriate
fasteners, tools, and mounts listed in each section. Installation items not provided
by Garmin should be available at most marine dealers. If you experience
difficulty installing the unit, contact Garmin Product Support or an installation
professional in your area.
The GPSMAP 2106/2110 is CANet compatible. See the GPSMAP 2106/2110 &
GPS 17 Installation Instructions for more information.
About This Manual
To get the most out of your new chartplotter, read this manual and learn the
operating procedures for your unit in detail. This manual is organized into the
following sections:
The Introduction contains the Table of Contents, Product Registration, and the
Software License Agreement.
The Getting Started section provides a unit overview and information that
provides basic working knowledge needed to use the GPSMAP 2106/2110.
The Basic Operation section provides you with details and step-by-step
instructions such as creating and using waypoints, navigating a route, and using
the FIND key.
The Main Pages section provides detailed explanations about each page in the
GPSMAP 2106/2110 and step-by-step directions on using the pages.
The Main Menu section provides detailed explanations about the Main Menu
and how to use it to configure your unit.
See the Using Sonar section if you have either a Garmin GSD 21 or GSD 22
sounder connected to your GPSMAP 2106/2110.
The Appendix contains specifications, regulatory information, unit care
information, optional accessories, and maintenance information. You can also find
warranty and FCC information in the Appendix.
An Index is provided at the end of the manual for reference.
Manual Conventions
This manual uses the term Warning to indicate a potentially hazardous situation,
which, if not avoided, could result in death or serious injury.
This manual uses the term Caution to indicate a potentially hazardous situation,
which, if not avoided, may result in minor injury or property damage. It may also
be used without the symbol to alert you to avoid unsafe practices.
3


Need help? Post your question in this forum.

Forumrules
1

Forum

garmin-gpsmap-2110

Reset search

  • I have acquired a Garmin 2110 with a GPS17.
    The cable between the two has been carefully cut - I assume to remove it from the previous vessel. I have connected all the cables together as per the Basic Installation shown in the handbook. All works fine.
    My question is how can i reconnect the two (front and rear) looms together. The wires from the GPS17 are too fine to solder and not of sufficient size as to allow connection by electrical Mobloc.
    Can anyone help me by telling me what they have used to connect these looms together?
    Thanks in anticipation
    Ian Hutchinson Submitted on 15-4-2021 at 11:46

    Reply Report abuse
  • I have just acquired a Garmin 2110 and GPS17.
    The wires that connect the two together have been carefully cut - I assume to enable the units to be removed from the previous vessel. I have connected all the wiring together as per the Basic Wiring diagram and all worked perfectly.
    However the wires from the GPS17 are extreamly delicate and will not (maybe my inexperience ) allow solder connections in order to make the installation complete. My question is what can I use to make a permanent fixing of the two (front and rear) looms?
    I have tried using a small mobloc but the wires in the GPS17 loom are too fine to make a good connection.
    Any help would be greatly appreciated
    Ian Hutchinson Submitted on 15-4-2021 at 11:25

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GPSMAP 2110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GPSMAP 2110 in the language / languages: English as an attachment in your email.

The manual is 6,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info