522226
17
Zoom out
Zoom in
Previous page
1/66
Next page
Receiver Status
Receiver status is indicated at the top left of the
page, with the current horizontal accuracy (estimated
position error, in feet or meters) at the top right. The
status will be shown as one of the following conditions:
Searchingthe GPS 12 is looking for any avail-
able satellites in view.
AutoLocatethe GPS 12is initializing and col-
lecting new almanac data. This process can take 5
minutes, depending on the satellites currently in
view.
Acquiringthe receiver is collecting data from
available satellites, but has not collected enough
data to calculate a 2D fix.
2D Nav (2D Navigation)at least three satel-
lites with good geometry have been locked onto and
a 2-dimensional position fix (latitude and longitude)
is being calculated. ‘2D Diff’ will appear when you
are receiving DGPS corrections in 2D mode.
3D Nav (3D Navigation)at least four satellites
with good geometry have been locked onto, and
your position is now being calculated in lati t u d e ,
longitude and altitude. ‘3D Diff’ will appear when you
are receiving DGPS corrections in 3D mode.
Poor Cvg (Poor GPSCoverage)the receiver
i s n t tracking enough satellites fora 2D or 3D fix
due to bad satellite geometry.
Not Usablethe receiver is unusable, possibly
due to incorrect initialization or abnormal satellite
conditions. Turn the unit off and back on to reset,
and reinitialize the receiver if necessary.
Simulatorthe receiver is in simulator mode.
EZinitOption Prompt
The Satellite Page also provides access to the EZinit
prompt whenever a position fix has not been calculated.
(The unit must be in searching, AutoLocate, acquiring,
simulator, or poor coverage mode.) This allows you to
reinitialize the unit (see Appendix A), and is useful if
you have traveled over 500 miles with the receiver off
and must initialize your new position. (The EZ
init
prompt will automatically appear if the receiver needs
to be initialized. The prompt may also appear during
normal use if the antenna is shaded or the unit is oper-
ated indoors.)
13
The signal strength bars at
the bottom of the page will
not appear until the GPS
12 has found the satellites
indicated at the bottom of
the screen.
REFERENCE
Receiver Status
& EZinit
If you travel more than
500 miles with the receiv-
er off, reinitialize the unit
to your new position by
using the EZinit feature.
To access EZinit, pre s s
ENTER from the Satellite
Page before any satellites
are acquired.
GPS12B 1/13/99 4:26 PM Page 13
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GPS12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GPS12 in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin GPS12

Garmin GPS12 User Manual - French - 66 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info