522254

Garmin GMR 24 Manual

6
Zoom out
Zoom in
Previous page
1/12
Next page
4
Garmin Radome Installation Instructions
Cable Runs
Route the cables as needed, depending on the type of mount you are using. It may be necessary to drill 31.7 mm (1.25") holes for routing the
power or network cable. Garmin provides a rubber cable grommet which may be used to cover a cable installation hole. The grommet does
NOT provide a waterproof seal. To waterproof the grommet, apply a marine sealant. Additional cable grommets can be purchased through
Garmin or a Garmin dealer.
When installing the power and network cables, observe the following:
• It is not recommended to cut the RJ-45 marine network cable, but the Garmin radome package includes a eld install kit if it is necessary to
do so. Make sure you save the end you cut. It is important that the wires are connected to the new RJ-45 connector the same way.
• To ensure safety, use the appropriate tie-wraps, fasteners, and sealant to secure the cable along a route and through any bulkhead or deck.
Avoid running the cables near moving objects, high-heat sources, or through doorways and bilges.
• Avoid installing the cables next to or parallel to other cables, such as radio antenna lines or power cables. This is essential to avoid
interference to or from other equipment. If this is not possible, shield the cables with metal conduit or a form of EMI shielding.
• Install the power cable as close to the battery source as possible. A minimum of 10.5 VDC is required during radar turn-on and operation.
Reference the wire gauge table on the previous page when using extended runs of wire between the power cable and the battery.
Final Wiring Connections
Making the nal wiring connections
1. ConnecttheBlackground(-)wiretothevessel’snegativepowerterminal.
2. ConnecttheRedpower(+)wire(withfuseholder)tothevessel’spositivepowerterminal.
Do not cut the fuse holder from the red wire. The fuse holder must remain in place for the Garmin radome to function correctly. Removing
the inline fuse holder may damage your boat's circuitry.
3. Forastand-alonenetwork(chartplotterandradaronly),attachtheRJ-45marinenetworkcabletotheRJ-45socketonthebackofthe
chartplotter.Foranexpandednetwork(chartplotter,radar,GMS10,etc.),attachtheRJ-45marinenetworkcabletoanopenRJ-45socket
ontheGMS10networkportexpander.TightentheRJ-45lockingringclockwiseuntilitisrmlysealed.
If you are using a Garmin GPSMAP 4000 or 5000 series chartplotter, you may not need a GMS 10 network port expander. The GPSMAP 4000
and 5000 series chartplotters have multiple RJ-45 sockets.
Stand-alone Network
Garmin radome
GPS 17/17X
Garmin
Chartplotter
When using the Garmin radome with a stand-alone network, the chartplotter and GPS antenna (GPS 17) must be installed according to their
installation instructions. This diagram only shows how a Garmin radome communicates with a stand-alone network and does not illustrate the full
wiring needs of the chartplotter or GPS 17/17X.
Both the Garmin radome and Garmin chartplotter must be connected to a power source according to their installation instructions. This diagram
only illustrates the network data connections.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GMR 24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GMR 24 in the language / languages: English as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin GMR 24

Garmin GMR 24 Installation Guide - German - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info