691460
2
Zoom out
Zoom in
Previous page
1/14
Next page
GHS™ 11
Installation Instructions
Important Safety Information
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
CAUTION
Always wear safety goggles, ear protection, and a dust mask
when drilling, cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite
side of the surface.
Tools Needed
Pencil
Drill
22 mm (
7
/
8
in.) drill bit or hole saw
3 mm (
1
/
8
in.) drill bit
4.76 mm (
3
/
16
in.) wrench
Phillips screwdriver
Marine sealant (optional)
Mounting Considerations
NOTICE
This device should be mounted in a location that is not exposed
to extreme temperatures or conditions. The temperature range
for this device is listed in the product specifications. Extended
exposure to temperatures exceeding the specified temperature
range, in storage or operating conditions, may cause device
failure. Extreme-temperature-induced damage and related
consequences are not covered by the warranty.
When selecting a mounting location, observe these
considerations.
To avoid interference with a magnetic compass, do not install
the device closer to a compass than the compass-safe
distance value listed in the product specifications.
A 10 m (32 ft) extension cable is included to connect the
handset to the VHF radio. You must select a mounting
location for the handset that allows this extension cable to
connect to the back of the VHF radio.
You can use the included screws to mount the extension
cable and the handset cradle mount on your boat. If the
included screws are not appropriate for the mounting surface,
you must purchase suitable hardware.
Installing the Extension Cable in the Mounting
Surface
Before drilling a hole to mount the extension cable, you must
make sure that the extension cable is long enough connect to
the back of the VHF radio from the selected mounting location.
1
Using the mounting plate
À
as a template, trace the cable
hole in the center of the mounting plate and mark the screw
locations.
2
Set the mounting plate aside.
Do not drill through the mounting plate.
3
Using a 22 mm (
7
/
8
in.) drill bit or hole saw, drill the center
cable hole
Á
in the mounting surface.
4
Using a 3 mm (
1
/
8
in.) drill bit, drill the pilot holes.
5
Apply marine sealant between the mounting plate and the
mounting surface to help seal the holes (optional).
6
Using the included screws, attach the mounting plate to the
mounting surface.
7
Connect one end of the extension cable to the microphone
relocation port on the back of the VHF radio, and route the
other end of the extension cable to the mounting location.
8
Feed the extension cable connector
Â
through the back of
the mounting surface.
9
Apply marine sealant around the extension cable connector
in the mounting plate to help seal the hole (optional).
10
Secure the extension cable connector to the mounting plate
using the weather cap
Ã
and the nut
Ä
.
11
Connect the handset to the extension cable.
Installing the Cradle Mount
1
Select a mounting location near the extension cable.
TIP: You can place the handset in the cradle mount, connect
the handset to the extension cable, and hold it against the
mounting surface to help determine the best location.
2
Using the cradle mount as a template, mark the screw
locations.
3
Set the cradle mount aside.
Do not drill through the cradle mount.
4
Using a 3 mm (
1
/
8
in.) drill bit, drill the pilot holes.
5
Using the included screws, secure the cradle mount to the
mounting surface.
Specifications
Specification Measurement
Dimensions (H×W×D) 154 × 69 × 40 mm (6.1 × 2.7 × 1.6 in.)
Weight 318 g (11.22 oz.)
Temperature range Operating: From -15° to 70°C (from 5° to
158°F)
Storage: From -20° to 70°C (from -4° to
158°F)
Compass-safe distance 60 cm (23.6 in.)
Water rating IEC 60529 IPX7*
*The device withstands incidental exposure to water of up to 1 m
for up to 30 min. For more information, go to www.garmin.com
/waterrating.
2 Installation Instructions
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GHS 11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GHS 11 in the language / languages: All languages as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info