522189
21
Zoom out
Zoom in
Previous page
1/26
Next page
Settings
GHC 10 Owner’s Manual 17

1. From the Heading screen, select  > > .
2. Select an option:
—set the function performed by the rst button on
the remote.
—set the function performed by the second button
on the remote.
—set the function performed by the third button on
the remote.
—disconnect the remote from the device.


On a GHP 10 autopilot system, if you disable the Shadow Drive, you must
set the autopilot to standby () to manually control the helm. Use
caution when disabling the Shadow Drive.
On a GHP 10V autopilot system, if you disable the Shadow Drive, any
adjustment to the helm completely disengages the autopilot.
Although the autopilot is congured for your boat during installation, you
may nd it necessary to adjust it depending on sea conditions.
Select  > > .

—enables the device to enter standby mode
automatically when you manually steer the helm, then engages the
heading hold again when you hold a steady course for a few seconds.
The Shadow Drive is not available on sailboats.
—Shadow Drive is activated when a certain
amount of pressure is placed on the helm. Adjust this setting if the
Shadow Drive is being falsely tripped or not activating properly. If the
autopilot disengages while the helm is steady, decreasing the sensitivity
value can help alleviate unwanted disengaging. If the Shadow Drive does
not disengage the autopilot correctly when you take the helm, increasing
the sensitivity value may help.
 This setting does not apply to a GHP 10V or GHP 12 autopilot
system.
—adjust the sea state ltering to set the heading
responsiveness. Set sea state ltering to 0% under normal operating
conditions. Increase sea state ltering in choppy conditions at low speeds
to reduce rudder activity and reduce wear on the autopilot system.
—enable the device to set the drive direction to
forward or reverse from the heading screen when the autopilot is in
standby mode. See page 4 for information about  direction control.
—(sailboats only) set the xed angle at
which the autopilot performs a tack or gybe maneuver with heading hold
engaged. Select an angle from 1° to 180°.
—(sailboats only) the autopilot delays steering a tack
or gybe after you initiate the maneuver using the remote or the device.
The delay counts down on the heading screen, and sounds an alarm when
the autopilot begins the tack or gybe. Select a delay from 0 to 15 seconds.
—(sailboats only) prevents the autopilot from performing
a gybe. The gybe inhibitor does not prevent you from manually
performing a gybe using the helm or step steering.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GHC10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GHC10 in the language / languages: English as an attachment in your email.

The manual is 1,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin GHC10

Garmin GHC10 Quick start guide - German - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info