674189
5
Zoom out
Zoom in
Previous page
1/24
Next page
Getting Started
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Update the maps and software on your device (Updating
Maps and Software Using a Wi
Fi Network, page 15).
Mount the device in your vehicle and connect it to power
(Mounting and Powering the Garmin fleet Device in Your
Vehicle, page 1).
Acquire GPS signals (Acquiring GPS Signals, page 1).
Adjust the volume (Adjusting Sound and Notification Volume,
page 15) and display brightness (Adjusting the Screen
Brightness, page 2).
Set up a vehicle profile (Adding a Vehicle Profile, page 2).
Navigate to your destination (Starting a Route, page 3).
Garmin fleet 770 Overview
À
Microphone for hands-free calling
Á
Volume control
Â
Power key
Ã
Micro USB power and data port
Ä
Map and data memory card slot
Å
3.5mm audio jack
Æ
Magnetic mount interface with 14 pin connector
Ç
Speaker
Mounting and Powering the Garmin fleet
Device in Your Vehicle
WARNING
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Both the device and its mount contain magnets. Under certain
circumstances, magnets may cause interference with some
internal medical devices, including pacemakers and insulin
pumps. Keep the device and its mount away from such medical
devices.
NOTICE
Both the device and its mount contain magnets. Under certain
circumstances, magnets may cause damage to some electronic
devices, including hard drives in laptop computers. Use caution
when the device or its mount is near electronic devices.
Before you use your device on battery power, you should charge
it.
1
Plug the vehicle power cable
À
into the mini-USB port on the
mount.
2
Press the mount
Á
onto the suction cup
Â
until it snaps into
place.
NOTE: The mount and suction cup may already be
assembled in the package.
The Garmin
®
logo on the mount should face right-side up. It is
easiest to connect the mount and suction cup when the
hinged arm on the suction cup is closed. The mount and
suction cup fit tightly, and you may need to press hard to
connect them.
3
Press the suction cup to the windshield, and flip the lever
Ã
back toward the windshield.
4
Place the back of the device onto the magnetic mount.
5
Select an option:
If your power cable has a vehicle power plug, plug it into a
power outlet in your vehicle.
If your power cable has bare wire connectors, follow the
wiring diagram included with your cable to connect the
cable to vehicle power.
Turning the Device On or Off
To turn the device on, press the power key, or connect the
device to power.
To put the device in power saving mode, press the power key
while the device is on.
While in power saving mode, the screen is off and the device
uses very little power, but it can wake instantly for use.
TIP: You can charge your device faster by putting it in power
saving mode while charging the battery.
To turn off the device completely, hold the power key until a
prompt appears on the screen, and select Off.
The prompt appears after five seconds. If you release the
power key before the prompt appears, the device enters
power saving mode.
Acquiring GPS Signals
When you turn on your navigation device, the GPS receiver
must collect satellite data and establish the current location. The
time required to acquire satellite signals varies based on several
factors, including how far you are from the location where you
last used your navigation device, whether you have a clear view
of the sky, and how long it has been since you last used your
navigation device. The first time you turn on your navigation
device, it may take several minutes to acquire satellite signals.
1
Turn on the device.
Getting Started 1
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Fleet 770 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Fleet 770 in the language / languages: English as an attachment in your email.

The manual is 2,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin Fleet 770

Garmin Fleet 770 User Manual - German - 28 pages

Garmin Fleet 770 User Manual - Dutch - 26 pages

Garmin Fleet 770 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info