522219
36
Zoom out
Zoom in
Previous page
1/40
Next page
28
Appendix B
Messages and Alarms
Battery Alarm — Battery voltage has fallen below the value entered in the Battery Alarm setup.
Battery Voltage High— Input voltage too high, unit will shut off. You must lower input voltage.
Boat is not Moving Fast Enough to Calibrate — Boat is not moving fast enough for the speed wheel to
provide a valid speed.
Can’t Send Waypoint — Unit was unable to transmit the waypoint via the NMEA WPL sentence. Check
wiring.
Can’t Read Voltages That High Limited To Top Of Range — Voltage value in the Battery Alarm setup is
higher than the unit can read.
Can’t Read Voltages That Low Limited To Bottom Of Range — Voltage value in the Battery Alarm
setup is lower than the voltage where the unit automatically turns off.
Deep Water Alarm — Deep Water Alarm depth has been reached.
Drift Alarm — Depth has changed by the amount entered in the Drift Alarm setup.
Fish Alarm — Displays icon and sounds beep (if enabled) when a fi sh is detected. (This alarm does not
display a message banner.)
Running Simulator — Unit is in Simulator Mode. This message will reappear after 2 minutes of inactivity.
(If the unit does not detect a transducer attached, it will automatically enter Simulator Mode.)
Shallow Water Alarm — Shallow Water Alarm depth has been reached.
Sonar Failed Unit Needs Repair — Internal problem with unit. Contact your dealer or Garmin Product
Support to have the unit serviced.
Timer Alarm — Timer Alarm value has counted down to 00:00:00.
Transducer Disconnected Sonar Turned Off — No transducer attached, bad cable/transducer or trans-
ducer cable was disconnected. If the transducer cable is removed while the unit is on, reconnect and cycle
power.
Water Speed Sensor is not Working — Speed sensor is not detected. Check Connections.
Water Temperature Alarm — Water Temperature Alarm setting has reached value above, below, inside, or
outside of specifi ed value(s).
The Fishfi nder 250/250C uses an on-screen
pop-up message system to alert you to unit
operating characteristics. Press the ENTER key to
acknowledge the message.
250C Manual.indd 28 1/27/2004, 3:55:26 PM
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Fishfinder 250C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Fishfinder 250C in the language / languages: English as an attachment in your email.

The manual is 1,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info