522190
12
Zoom out
Zoom in
Previous page
1/32
Next page
6 Fishfinder 90/140 Owner’s Manual
INSTALLING YOUR FISHFINDER
4. Wrap the two ends of the cable tie around the motor
body. Place the pointed end of the cable tie through
the fastener hole on the opposite end and pull it
through until it is snug but not tight. (The cable tie
clicks when you pull it.)
5. Position the transducer so that it is parallel with the
bottom when in use, and make sure the gasket is
aligned properly. Pull the cable tie end until tight.
Trim off the excess, if necessary. Tighten the 10-32
locking nut until it touches the mounting bracket and
then tighten 1/4 turn more. (Do not overtighten.)
6. Route the 30’ (9 m) transducer cable using the
supplied cable ties to secure the cable to the motor
shaft. You can fill the forward-facing portion (except
the cable tie pocket) of the transducer mount with
sealant to avoid accumulating debris.
Mounting the Transducer on a Transom
When selecting a transom mount location, consider the
following for optimal performance:
For your sonar to operate properly, the transducer
must be located in calm water. DO NOT mount the
transducer behind strakes, rivet lines, struts, fittings,
water intake, discharge ports, eroding paint, or
anything that creates turbulence.
Mount the transducer as close to the center of the
boat as possible.
DO NOT cut the transducer lead. (This voids your
warranty.)
DO NOT mount the transducer in locations where it
might be jarred when launching, hauling, trailering,
or storage.
DO NOT mount the transducer in the path of the
prop on single-drive boats. The transducer can cause
cavitation that can degrade the boat’s performance
and damage the prop. On twin-drive boats, mount
the transducer between the drives, if possible.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Fishfinder 140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Fishfinder 140 in the language / languages: English as an attachment in your email.

The manual is 1,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info