Manual Garmin Delta InBounds system (page 7 of 16) (English)

691406

Zoom out

Zoom in

1/16

Select a collar band.

Loop the collar strap

through the collar band.

Place the device

in the loop between the collar strap and

the collar band.

Snap the collar band onto the device.

Pull the collar strap until it is tight across the front of the

device.

Fitting the Collar on Your Dog

CAUTION

To prevent irritation from the contact points, remove the collar

for at least eight hours out of every 24-hour period.

This device is not intended for human use. Do not attempt to

use on any person.

Do not spray the device or collar with harsh chemicals including

but not limited to flea or tick spray. Always ensure that any flea

or tick spray that is applied to the dog is completely dry before

placing the collar on the dog. Small amounts of harsh chemicals

can damage the plastic components and collar laminate.

In order to effectively train the dog, the collar and device must fit

the dog properly. If the collar is too loose or positioned

incorrectly, stimulation may be inconsistent. This can delay or

prevent successful training.

Position the device at the front of the dog's neck, with the

status LED facing toward the dog's chin and the contact

points against the throat.

TIP: For bark correction, the device contact points should be

positioned near the dog's vocal cords. This location varies

based on the breed of dog. If the device does not seem to

detect the dog's barks, you should move the device closer to

or farther from the dog's body to find the ideal location.

Tighten the strap so that it is very snug around the dog's

neck, and fasten the buckle.

NOTE: The collar should fit tightly and should not be able to

rotate or slide on the dog's neck. The dog must be able to

swallow food and water normally. You should observe your

dog's behavior to verify that the collar is not too tight.

Wiggle the device to work the contact points through the

dog's coat.

NOTE: The contact points must have contact with the dog's

skin to be effective.

If the strap is too long, cut off the excess, leaving at least

8 cm (3 in.) to spare.

TIP: You can mark the hole used to fasten the buckle for

future reference.

Selecting and Installing the Contact Points

For best results, you should install contact points based on your

dog's coat.

Select the correct contact point length for your dog's coat

type:

• For dogs with thicker coats, use the longer contact points.

• For dogs with shorter coats, use the shorter contact

points.

Twist the contact points into the collar until tight.

When you put the collar on the dog, make sure the contact

points are tight against the neck.

Training Methods

Stimulation: Applies a brief stimulation when the dog enters the

boundary, for a maximum of 8 seconds. You can adjust the

stimulation intensity level in the Garmin Canine

™

app (Garmin

Canine App, page 6).

TIP: You can also adjust stimulation intensity levels from the

base unit (Setting the Intensity Level Using the Base Unit,

page 3).

NOTE: If your dog breaches the boundary, the dog collar

device applies stimulation for up to 1 minute and then stops

to allow for a safe return.

Tone: Activates an audible tone. A tone can be used as either a

positive or negative training cue, depending on your training

program.

Vibration: Applies vibration to the dog the entire time the dog is

at the boundary, for a maximum of 8 seconds. The

effectiveness of vibration may vary based on the dog's

temperament and experience.

NOTE: If your dog breaches the boundary, the dog collar

device applies vibration for up to 1 minute and then stops to

allow for a safe return.

Setting the Intensity Level Using the Base Unit

On the base unit, select a dog.

Select Stimulation.

Select an intensity level appropriate for the training phase

and your dog.

Choosing the Correct Intensity Level

Set the intensity to the lowest level (Setting the Intensity

Level Using the Base Unit, page 3).

Observe the dog for a reaction, such as a head shake, neck

movement, or just a change in expression.

Sometimes dogs will vocalize due to the surprise of the

electrical stimulation. If the dog vocalizes more than once,

the intensity level is too high for beginning training.

If there is no reaction, increase the intensity level by one level

until the dog has a slight but recognizable reaction to the

stimulation.

The intensity level that causes a slight but recognizable reaction

is your dog's baseline level for beginning collar training. You do

not need to, and should not, apply this intensity selection test

again.

After you begin training, the dog’s performance guides your

intensity selection. As the dog advances in training, you may

need to change the level depending upon the training situation.

Dog Training 3

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Delta InBounds system in the language / languages: English as an attachment in your email.

The manual is 1,86 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Garmin Delta InBounds system Manual

Product: