563575
18
Zoom out
Zoom in
Previous page
1/24
Next page
Setting the Foot Pod Mode
You can set your device to use foot pod data instead of GPS
data to calculate pace.
1Select the action key.
2Select Setup > Fitness > Foot Pod Speed.
3Select an option:
Select Indoor when you are training indoors without GPS.
Select Always On when training outdoors, when your
GPS signal is weak, or when you lose satellite signals.
Going for a Run Using a Foot Pod
Before you go for a run, you must change the profile to running
(Changing Profiles), and pair the foot pod with your device
(Pairing Your ANT+ Sensors).
When your device can not acquire satellite signals, such as
when running indoors on a treadmill, you can use the foot pod
to measure your running distance.
1Install your foot pod according to the accessory instructions.
2Select the action key.
3Select Setup > Fitness > Foot Pod Speed > Indoor.
4Hold to start the timer.
5Start running.
You can hold to pause and resume your run. You can hold
to mark a lap.
6Hold to stop the timer.
The device automatically saves your run.
Foot Pod Calibration
Calibrating your foot pod is optional and can improve accuracy.
There are three ways to adjust the calibration: distance, GPS,
and manual.
Calibrating Your Foot Pod by Distance
Before you can calibrate your device, you must pair your device
with the foot pod (Pairing Your ANT+ Sensors).
For best results, the foot pod should be calibrated using the
inside lane of a regulation track or an exact distance. A
regulation track (2 laps = 0.5 mi. or 800 m) is more accurate
than a treadmill.
1Select the action key.
2Select Setup > ANT Sensor > Foot Pod > Calibrate >
Distance.
3Select Start to begin recording.
4Run or walk 0.5 mi. or 800 m.
5Select Stop.
Calibrating Your Foot Pod by GPS
Before you can calibrate your device, you must acquire GPS
signals, and pair your device with the foot pod (Pairing Your
ANT+ Sensors).
1Select the action key.
2Select Setup > ANT Sensor > Foot Pod > Calibrate >
GPS.
3Select Start to begin recording.
4Run or walk approximately 0.62 mi. or 1 k.
The device informs you when you have traveled far enough.
Calibrating Your Foot Pod Manually
Before you can calibrate your device, you must pair your device
with the foot pod (Pairing Your ANT+ Sensors).
Garmin recommends manual calibration if you know your
calibration factor. If you have calibrated a foot pod with another
Garmin product, you may know your calibration factor.
1Select the action key.
2Select Setup > ANT Sensor > Foot Pod > Calibrate >
Manual.
3Adjust the calibration factor:
Increase the calibration factor if your distance is too low.
Decrease the calibration factor if your distance is too high.
Using an Optional Bike Cadence Sensor
You can use a compatible bike cadence sensor to send data to
your device.
Pair the sensor with your device (Pairing Your ANT+
Sensors).
Create a custom profile for biking (Creating a Custom
Profile).
Update your fitness user profile information (Setting Your
Fitness User Profile).
Device Information
Viewing Device Information
You can view the unit ID, software version, and license
agreement.
1Select the action key.
2Select Setup > About.
Updating the Aviation Database
Before you can update the aviation database, you must create a
Garmin account and add your device.
The aviation database is valid for 6 months at a time and
includes only airport locations and basemap.
1Connect your device to a computer using the included USB
cable.
2Go to www.flyGarmin.com.
3Log in to your Garmin account.
4Follow the on-screen instructions to update the aviation
database.
Updating the Software
NOTE: Updating the software does not erase any of your data
or settings.
1Connect your device to a computer using the USB cable.
2Go to www.garmin.com/products/webupdater.
3Follow the on-screen instructions.
Device Care
NOTICE
Do not use a sharp object to clean the device.
Avoid chemical cleaners, solvents, and insect repellents that
can damage plastic components and finishes.
Thoroughly rinse the device with fresh water after exposure to
chlorine, salt water, sunscreen, cosmetics, alcohol, or other
harsh chemicals. Prolonged exposure to these substances can
damage the case.
Avoid pressing the keys under water.
Avoid extreme shock and harsh treatment, because it can
degrade the life of the product.
Do not store the device where prolonged exposure to extreme
temperatures can occur, because it can cause permanent
damage.
14 Device Information
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin D2 Pilot at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin D2 Pilot in the language / languages: English as an attachment in your email.

The manual is 4,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin D2 Pilot

Garmin D2 Pilot Quick start guide - English - 4 pages

Garmin D2 Pilot User Manual - German - 26 pages

Garmin D2 Pilot User Manual - French - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info