589669
17
Zoom out
Zoom in
Previous page
1/22
Next page
Before you pair the ANT+ accessory with your Garmin
device, move 10 m (32.9 ft.) away from other ANT+
accessories.
Bring the Garmin device within range 3 m (10 ft.) of the
ANT+ accessory.
After you pair the first time, your Garmin device automatically
recognizes the ANT+ accessory each time it is activated.
This process occurs automatically when you turn on the
Garmin device and only takes a few seconds when the
accessories are activated and functioning correctly.
When paired, your Garmin device receives data from only
your accessory, and you can go near other accessories.
DC 50 Battery Replacement Instructions
DC 50 Components
ÀBack plate
ÁPower key
ÂBattery connector
ÃBattery cover
ÄBattery
ÅPower connector
Removing the Old Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You must also have a small Phillips
screwdriver.
1Remove the six screws from the outer edges of the back
plate.
NOTE: You should leave the two inner screws in place.
2Pry off the back plate.
3Disconnect the battery connector and power connector.
4Remove the screws that secure the battery cover.
5Remove the battery cover and the battery.
Remember the orientation of the battery. You must install the
new battery the same way.
After you remove the old battery, contact your local waste
disposal department to properly recycle the battery.
Installing the New Battery
Before you replace the battery, you must remove the old battery
(page 13). You also must have a small Phillips screwdriver. You
may need a small flat screwdriver.
1Install the new battery using the same orientation as the old
battery.
The connector À should face the end nearest the power key,
and the bump Á where the wires connect to the battery
should face toward the side with the charging clip contacts.
2Replace the battery cover.
3Replace the screws to secure the battery cover.
4Connect the battery connector and power connector.
You may need to use a flat screwdriver to help secure the
connectors.
5Select the power key to test the connections.
When properly connected, a tone is emitted and the status
LED blinks green.
6Turn off the device.
7Verify the gasket located inside the bottom cover is fully
seated.
8Replace the back plate.
9Replace the six screws to secure the back plate.
After you install the new battery, charge the collar completely.
Replacing the Collar Strap
Before you replace the collar strap, you must remove all dirt,
water, and debris from the device (page 11).
1Pull the collar strap out of the GPS antenna, VHF antenna
guide, and the dog device.
You may need to push and pull the collar strap to properly
remove it. You may need to loosen the screw on the GPS
antenna case, but do not remove them.
2Thread the new collar strap through the dog device, VHF
antenna guide, and GPS antenna.
3If necessary, tighten the screws that secure the GPS
antenna case.
VHF Radio Information
This product may be used only on specific radio frequencies,
which vary depending on the country of use. See the product
packaging or go to www.garmin.com/astro-legal for details
regarding the radio frequency of this product.
Replacing the VHF Antenna in the Dog Collar Device
NOTICE
Do not excessively bend the band that connects the main
device case with the GPS antenna.
When the cover is removed, do not disturb the sealant opposite
the VHF antenna, because this can damage the waterproof seal
of the dog collar device.
Before you replace the VHF antenna, you must remove all dirt,
water, and debris from the device. Also, you need a small
Phillips screwdriver.
1Remove the 4 screws À from the cover over the VHF
antenna.
NOTE: You should note the location of the one short screw
Á.
Appendix 13
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Astro320 - DC50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Astro320 - DC50 in the language / languages: English as an attachment in your email.

The manual is 3,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin Astro320 - DC50

Garmin Astro320 - DC50 User Manual - German - 24 pages

Garmin Astro320 - DC50 User Manual - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info