657463

Garmin Alpha100 TT 10 Manual

12
Zoom out
Zoom in
Previous page
1/26
Next page
dog as long as the key is held, for a maximum of 8 seconds.
Your stimulations should typically be far shorter than 8 seconds.
Continuous stimulation can be useful when first starting training
with your dog.
You can also train using a tone (T). When you select T for a
key, the key press activates an audible tone instead of
stimulation. Using the tone can be a helpful training tool.
NOTE: The tone volume cannot be changed. Changing the
intensity of the tone does not adjust the volume.
Choosing the Correct Intensity Level
1
Set the training keys to the lowest level (page 6).
2
Press a training key.
3
Observe the dog for a reaction, such as a head shake, neck
movement, or just a change in expression.
Sometimes dogs will vocalize due to the surprise of the
electrical stimulation. If the dog vocalizes more than once,
the intensity level is too high for beginning training.
4
If there is no reaction, increase the intensity level by one
level until the dog has a slight but recognizable reaction to
the stimulation.
The intensity level that causes a slight but recognizable reaction
is your dog's baseline level for beginning collar training. You do
not need to, and should not, apply this intensity selection test
again.
After you begin training, the dog’s performance guides your
intensity selection. As the dog advances in training, you may
need to change the level depending upon the training situation.
Training the Dog to Heel and Sit with the Collar
Before you begin training your dog using the collar, your dog
must show a grasp of the "heel," "sit," and "come" commands
while on the leash, you must put on the collar (page 4), and you
must find the correct intensity level (page 8).
When beginning collar training, start with the "heel" and "sit"
commands.
1
With the dog at your side on a leash, pull up on the leash,
and command the dog to "sit."
2
If the dog does not sit immediately, press a training key
briefly, and repeat the command to "sit."
3
Reward the dog with praise when the dog obeys the
command.
After the dog begins obeying the "sit" command without
collar stimulation, you should move on to the "heel"
command.
4
With the dog at your side on a leash and with the collar on,
command “heel” and begin walking forward while gently
pulling on the leash.
5
If the dog not heel, press a training key briefly, repeat the
command to “heel”, and move in another direction or pull
back on the leash.
6
Reward the dog with praise when the dog obeys the
command.
Training the Dog to Come Here with the Collar
Before you begin training your dog to come "here" using the
collar, your dog must have a strong grasp of the "heel" and "sit"
commands using the collar, you must put on the collar (page 4),
and you must find the correct intensity level (page 8). Also, you
may need to use a long leash to effectively train "here."
1
With the dog in a sitting position, move away to the end of
the leash.
2
Command the dog to come “here.”
3
If the dog does not move immediately toward you, press a
training key briefly, gently tug on the leash, and repeat the
command to come "here."
4
Reward the dog with praise as soon as the dog begins to
move toward you.
5
If the dog begins to veer away, press a training key briefly,
and repeat the command to come "here."
Contact Tracking
You can track other hunters so you know where they are at all
times. You can also send messages to your contacts. One
Alpha handheld device can track up to 20 devices (TT dog
collar devices and Alpha handheld devices).
Adding a Contact Over MURS/VHF
Before you can add a contact over MURS/VHF, you should be
near the contact, for best results.
You can add fellow hunters to your handheld device so you can
track them on the map (page 8) and send messages to them
(page 8).
1
On your handheld device, select > Contacts > Add.
2
Bring the two handheld devices near each other, and select
Yes on your handheld device.
3
On the contact's handheld device, select > Contacts >
Pair.
4
On your handheld device, enter the name of the contact, and
select > OK.
The contact is added to your handheld device.
If you would like to be added to the hunter's handheld device,
repeat this procedure using the hunter's handheld device.
Adding a Contact Using the ID
Before you can add a hunter using the contact ID, you must
have the hunter find the contact ID (page 8) and send it to
you.
If you are not nearby the hunter you want to add, you can add
the hunter using the contact ID.
1
On your handheld device, select > Contacts > Add.
2
When asked if you are near the other handheld device,
select No.
3
When asked if you know the ID, select Yes.
4
Select the correct ID for the contact you are adding.
5
Enter the name of the contact, and select > OK.
The contact is added to your handheld device.
If you would like to be added to another hunter's handheld
device using your contact ID, repeat this procedure using the
hunter's handheld device.
Sending a Message to Your Contacts
You can send and receive automated messages. There are 18
messages choose from, such as "Help" and "I'm Coming."
1
Select > Contacts > Message.
2
Select a message.
The message is sent to your contacts with your name before the
message. Anyone tracking your handheld device receives the
message.
Tracking a Contact
You can keep track of contacts' locations using the map.
Select .
Finding Your Contact ID
Select Setup > Contacts > Pairing Setup.
The contact ID for your handheld device is listed under ID.
8 Contact Tracking
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Alpha100 TT 10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Alpha100 TT 10 in the language / languages: English as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info