724657
15
Zoom out
Zoom in
Previous page
1/19
Next page
25cc 4 Stroke Petrol Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. YR-HT250 • 10/2017 • 52742
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. YR-HT250 • 10/2017 • 52742
25cc 4 Stroke Petrol Hedge Trimmer
26 27
Cleaning the Air Filter
1. To open the air lter cover (5) to access the air
lter (6), place your thumb and forenger on the
opposite sides of the air lter latch. Push down
simultaneously with thumb and forenger to
release the tabs on each side of the latch, then
using your other hand, open the air lter cover (5)
(Fig Y).
2. Pull out the air lter (6).
3. Wash the air lter (6) in soap and water. DO NOT USE PETROL!
4. Air dry the air lter (6).
5. Reinstall the air lter (6) over the 3 locating spigots, and ensure the air lter
sits in the recess provided, then close the air lter cover (5), ensuring both
the tabs are back into place on the latch.
CAUTION: Replace lter if frayed, torn, damaged or unable to be cleaned.
Replacement air lters are available for purchase by calling 1800 909 909 or by
emailing help@powertoolsupport.com
Carburettor Adjustment
The carburettor is pre-set at the factory for optimum performance. If further
adjustments are necessary take your unit to a
qualied Service Agent.
Spark Plug
WARNING: Ensure the engine is switched o before
undertaking this maintenance task.
Starting failure is often caused by a fouled spark plug.
Periodically clean the spark plug and replace with a
new one if necessary.
NOTE: Spark plug gap = .025 in. (.635mm) (Fig Z).
To gain access to the spark plug (8), the spark plug cover / front housing (7)
needs to be moved.
1. Using the supplied 4mm hex key (23), remove
the centre xing screw of the spark plug cover /
front housing (7) by rotating in an anti-clockwise
direction (Fig AA).
2. Pull the front cover forward, and then start to
rotate to the left hand side (Fig AB) until you are
able to access the spark plug (8).
3. Use the supplied spark plug spanner (22) to
remove the spark plug (8), by turning it in an
anti-clockwise direction.
4. Clean and adjust the spark plug gap to
0.6 - 0.7mm. Replace any damaged or visibly
worn plug with a new spark plug.
5. Re-Install the spark plug (8) nger tight, then
tighten with the supplied spark plug spanner (22).
Do not over-tighten.
6. Re-install the spark plug cover / front housing
(7) and secure back in position by applying the
centre xing screw and tightening by using
the supplied 4mm hex key (23) in a clockwise
direction.
NOTE: If your spark plug becomes worn,
replacements are available from most hardware
stores, service centres, or petrol product repair
shops.
Servicing
It is recommended once you rst use your
product to get it serviced after 15 hours of use.
From thereafter, service the product every 2 years.
Y.
Z.
AB.
AA.
TIGHTEN
LOOSEN
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline YR-HT250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline YR-HT250 in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info