724631
20
Zoom out
Zoom in
Previous page
1/21
Next page
1100W Garden Pump
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. XKJ-1109PE • 1/2019 • 44268
(toll free)
AFTER SALES SUPPORT
(toll free)
1100W Garden Pump
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL: №. XKJ-1109PE • 1/2019 • 44268
36 37
Troubleshooting Cont: Troubleshooting
Problem
Possible Cause Solution
Pump cycles on & o
in Automatic Mode.
Leak in pipe work.
Damage to sensor.
A small leak is sucient to cycle the pump.
Check ALL plumbing.
Check one of the supplied ttings are used
on outlet of pump.
Take to service centre.
Pump constantly
needs priming.
Non-return valve. Remove and check the non-return valve.
Clean or if damaged, replace.
Water ows through
pump when pump is
o in time mode.
Check height of water inlet. Water pressure on inlet must not exceed
0.5PSI or 0.4 metres in height.
Increase the height of the mounting of the
pump to achieve the above.
Problem
Possible Cause Solution
Motor fails to start.
No mains supply.
Check display for mode.
In Ever run mode.
In Automatic Mode.
In time mode.
Internal Thermal Cut out.
Check power point is turned on.
Check mains fuse or circuit breaker.
Check power point with another working
appliance.
If power point is working, and no display
on pump, take pump to service centre.
Change mode to Ever run mode to ensure
pump is operating.
Take to service centre.
Open outlet tap to ensure full ow.
Take to service centre.
Reset time function.
Take to Service centre.
If pump has been running continually
disconnect and leave for 20 minutes and
then retry.
Take to service centre.
No water intake.
Intake water line not in water.
Pump has not been primed
correctly.
Air on intake side of pump.
Intake valve not sealing.
Intake lter restricted.
Suction height.
In Automatic Mode.
Check the intake hose.
Lower the intake further into water.
Remove lter and non-return valve and ll
pump with water. Re assemble.
Check the tting into the pump and
connection. Must be fully sealed.
Check the intake hose has not collapsed
or has been split.
Remove lter and non-return valve.
Clean lter and valve and replace.
Replace if these parts are damaged or
cannot be cleaned.
Check the suction height of the intake
hose. It must not exceed 7 metres .
Check the outlet tap is open.
Inadequate output.
Suction height.
Check the lter.
Check intake hose is in water.
Check the height of the outlet.
Check hose diameter and length.
Check the suction height of the intake
hose. It must not exceed 7 metres .
Clean or replace.
Check the intake hose is deep enough and
air is not being drawn in.
Must not exceed 46M.
Note: The higher the outlet, the ow is less.
Hoses / pipes should be min 19mm or
performance will be reduced.
Description of symbols
The rating plate on your product may show symbols.
These represent important information about the product or instructions
on its use.
Conforms to relevant standards for electrical safety
and EMC Compliance.
Read these instructions for use carefully.
Warning.
Technical Specications
Voltage: 220-240V~50Hz
Input Watts: 1,100W
Delivery capacity max: 3,600 l/h
Delivery height max: 46m
Pressure max: 4.6 bar (0.46 Mpa)
Height max: 7 m
Pressure / connection: 19mm hose or 3/4” BSP
Water temperature max.: 35°C
Suction Connection: 1” BSP
Protection type: IP44
Product Weight: 10.8kg
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline XKJ1109 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline XKJ1109 in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info