Understanding and using these operating instructions 750W Submersible Water Pump
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. LKS-756W • 08/2015 • 49119
(toll free)
10
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
750W Submersible Water Pump
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. LKS-756W • 08/2015 • 49119
Important notes on the range of operation of the
Submersible Water Pump
• The Pump will always leave a minimum depth of water around the Pump
base of 30 - 50mm regardless of the setting of the float.
• The Pump is capable of pumping water from a depth of 7M down
to 30-50mm.
• The Pump will require a MINIMUM depth of water of 100mm to self prime
and start to pump water.
• The Pump is capable of lifting water through the outlet to a MAXIMUM
height of 8M.
• The approx. range of water depth under the operation of the oat
switch is:
- Short float cable setting: 350mm – 200 mm of water
- Long Float cable setting: 500mm – 70 mm of water
Setup / Assembly / Preparation for Operation
WARNING: Ensure the submersible Pump is disconnected from the mains
power supply before undertaking the following assembly / preparation.
WARNING: Do NOT put your hands or other body parts into the water
when the Pump is in operation and connected to the 240V mains power.
In a faulty condition, this could result in electrocution.
WARNING: Do not submerge the Pump and turn on WITHOUT connecting
a pipe to the outlet of the Pump. Failure to adhere to this point will result in
the Pump spinning and twisting the input cable and the float switch cable
creating a potential dangerous condition.
Note: Do not carry the Pump by the power cable as it will damage the
Pump and cable which will void warranty. Use the handle or carry the unit
to transport.
