724677
16
Zoom out
Zoom in
Previous page
1/32
Next page
26cc 2-Stroke Petrol Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com 1800 909 909
MODEL: №. 43671 • 10/2016 • HTKS26 (toll free)
14
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com1800 909 909
26cc 2-Stroke Petrol Hedge Trimmer
MODEL: №. 43671 10/2016 HTKS26
Operating Instructions
Stopping the Engine
Emergency Stopping Procedure
When it is completely necessary to stop the engine immediately, PRESS the
on/off switch (10) to the OFF position (position “O”) until the engine stops.
Normal Stopping Method
For normal stopping, release the throttle trigger (11) and allow the engine
to return to its idle speed. Press the on/off switch (10) to the OFF position,
marked with an O, until the engine stops completely.
Operation of the Throttle Trigger
The operation of the hedge trimmer is fully controlled from the rear
handle (15).
The throttle trigger (11) fully controls the hedge trimmer as follows.
1. With the motor running and the throttle trigger (11) not being pressed
or locked in for starting, the speed of the motor is at idle and at idle, the
blades are NOT engaged.
2. To engage the blades (1), the motor needs to accelerate.
To increase the speed of the motor, press the safety lever (14) down first
and then squeeze the throttle trigger (11). The further you squeeze the
throttle trigger (11), the faster the motor will run. During the increase in
motor speed, the blades (1) will engage.
3. To slow the hedge trimmer, release the throttle trigger (11) to obtain
the desired speed. To return the motor to the idle speed and completely
disengage the blades (1), release the throttle trigger (11) completely.
4. Note, Before you can operate the throttle trigger (11), you MUST depress
the safety lever (14)
Starting a Warm Engine
(Engine has been stopped for no more than 15-20 minutes)
1. Move the on/off switch (10) to the run position and pull the recoil starter
(8) cord again. The engine should start with one or two pulls. If the engine
fails to start after 6 pulls, repeat steps 2 through 9 of the “Starting a Cold
Engine instructions.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline HTKS26 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline HTKS26 in the language / languages: English as an attachment in your email.

The manual is 2,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info