724658
23
Zoom out
Zoom in
Previous page
1/36
Next page
4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com 1800 909 909
MODEL: №. DM46P-DO140 08/2017 57774 (toll free)
AFTER SALES SUPPORT
(toll free)
4 Stroke Petrol Lawn Mower
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. DM46P-DO140 • 08/2017 • 57774
21
EMERGENCY STOPPING
In the event the on/off switch (2) does not stop the engine, the following
processes will assist.
NEVER move the mower, or attempt to move the mower if the controls.
DO NOT turn o the motor.
DO NOT attempt to lift or tip the mower on its side.
1. In the event the OFF switch (2) does not turn off the motor, press the primer
bulb fully approximately 10 times or continue to push the primer until the
engine stalls.
2. If this fails to stop the engine, remove the spark plug cap from the spark
plug (24).
IMPORTANT: If the spark plug method is used, it is recommended to wear
a rubber glove when grasping the spark plug cap.
Persons with heart conditions or any medical condition which can be
affected by electric shock should not attempt this method.
3. NOTE: If the above methods do not stop the mower, let the mower
continue to run until the tank runs out of petrol.
- DO NOT Panic.
- DO NOT put your fingers anywhere near the cutting deck.
- DO NOT leave the mower unattended if the run down method is used.
When the motor has stopped, the fuel should be drained from the fuel tank
(14), spark plug cap (24) removed (if not already removed), and the mower
must NOT be restarted until the problem has been fixed by an Authorised
Service Agent (Refer to page 28 for information relating to finding your
nearest Service Agent).
Important Primer bulb information.
The priming bulb (22) pump is designed to deliver fuel directly into the
engine for easy start.
Follow these guidelines and you should have trouble free starting.
For first starting at the beginning of the mower session, pump the priming
bulb (22) 2-3 times. DO NOT EXCEED 3 pumps.
To restart a cold engine i.e after the engine has started and run for just a short
time, you will only need to pump the priming bulb (22) once.
DO NOT EXCEED 2 pumps.
To restart a hot engine, you will not need to pump the priming bulb (22) at all.
NOTE: If you over pump the engine, it will not start.
DO NOT re-pump the engine priming bulb (22).
Continue to pull the recoil starter (16) and after a number of pulls the engine
will start.
TIGHTEN
Emergency Stopping
23


Need help? Post your question in this forum.

Forumrules
1

Forum

gardenline-dm46p-do140

Reset search

  • hi, can you help me with the carburate issue, i need to replace it what the model number so i can search EBay thanks Submitted on 21-6-2022 at 04:29

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline DM46P-DO140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline DM46P-DO140 in the language / languages: English as an attachment in your email.

The manual is 2,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info