724647

Gardenline BC35TS-2 Manual

8
Zoom out
Zoom in
Previous page
1/26
Next page
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. BC35TS-2 • 08/2018 • 49290
(toll free)
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. BC35TS-2 • 08/2018 • 49290
12 13
Operation of the Brushcutter / Line Trimmer
Adding and Checking the oil
IMPORTANT: The motor of this brushcutter / line trimmer is packed with
NO OIL in the motor. Prior to starting the motor, oil MUST be added to the oil
reservoir (24). Failure to add sucient oil will result in damage to the motor
which is NOT covered under the warranty of the unit.
NOTE: This is a 4 stroke brushcutter / line trimmer. The motor sump MUST
be lled with 70mL of SAE 10W/30 BEFORE starting. Fresh unleaded fuel
must be used in this unit. Do not use ethanol based fuels.
Do NOT mix oil with fuel. Oil must be separately poured into the sump of
the motor as follows, and also the oil level MUST be checked every time the
line trimmer / brushcutter is used.
NEVER attempt to remove the oil dipstick (24) while the motor is running.
ENSURE the motor is not running when the oil level is being checked.
On a new unit, the motor needs to be lled with 70mL of SAE 10W/30
engine oil.
To initially ll with oil or to check the oil level,
follow the process below.
1. Lay the unit down so that the fuel tank bracket
(39) is resting on a secure surface, or on the
ground. Clean the area directly around the oil
reservoir (24) (Fig. A).
2. Clean the area directly around the oil dipstick
(24), and then fully remove/unthread the oil
dipstick in an anti clockwise direction.
3. On a new unit which has not previously been
lled with oil, measure 70mL of SAE 10W/30 oil
and pour into the oil reservoir (24) where the
dipstick was removed.
4. Clean the dipstick portion of any oil residue and
then insert the dipstick fully into the reservoir,
however, DO NOT THREAD the dipstick into the
reservoir. Hold the dipstick in place for a few
second and then remove (Fig B).
5. Check the oil mark on the dipstick (24). If the
oil level is near or below the lower limit mark
on the dipstick (Fig C), oil should be added in
small increments, into the oil reservoir, and
repeat steps 3,4 & 5 until it is up to the bottom
edge of the oil reservoir (Fig D). Be careful not to
overll or add oil past the bottom edge of the
oil reservoir.
6. IMPORTANT: The motor should NEVER be
started if the oil level is below the low oil mark.
Always check the oil level before starting
ensuring the brushcutter / line trimmer is
positioned as per step 1 for checking.
7. When the oil level is at the upper oil level mark;
the bottom edge of the oil reservoir (Fig D),
replace the dipstick and thread in the dipstick in
a clockwise direction until the dipstick is rmly
in place. The Sealing O ring on the shoulder of
the dipstick should be fully compressed when
the dipstick is rmly hand tightened.
A.
B.
C.
LOWER
MARK
D.
UPPER
MARK
Operation of the Brushcutter / Line Trimmer
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline BC35TS-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline BC35TS-2 in the language / languages: English as an attachment in your email.

The manual is 1,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info