724670
38
Zoom out
Zoom in
Previous page
1/42
Next page
Understanding and using these operating instructions
190cc 4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com 1800 909 909
MODEL: №. 49291 • 08/2016 • 49291 (toll free)
36
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
190cc 4 Stroke Petrol Lawn Mower
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. 49291 08/2016 49291
Troubleshooting
Problem Possible Cause Solution
Engine does not start Fuel tank (25) is empty
Oil tank is empty
Motor throttle control (5)
is not in correct starting position
Spark plug (27)
Blades hitting the grass to be cut
Check the fuel tank (25), and refuel if
required.
Check the level of the oil dipstick (24),
and if low or empty, add oil
Move the motor throttle control (5)
to the correct “START position
Clean or replace if dirty or worn
Increase the cutting height of the mower
so the blades do not make contact with
the grass on start up
Cutting / Engine
performance
decreases
Cutting height
4 x swing blades (30) are dull or blunt
When using side discharge chute (20)
60L hard catcher (14) is full
Increase the cutting height using the
8 height adjustment lever (18)
Replace the blades with new / sharp
blades.
Clean around the side ejector chute (20)
NOTE: Always ensure the engine is turned
off before undertaking this task.
Empty 60L hard catcher (14)
60L hard catcher
is not filling up to
optimum level
Cutting height too low
When Mulching, piles of grass are left
behind the mower
Grass is wet
4 x swing blades (30) are dull or blunt
Rear discharge chute (16) is blocked
Increase the cutting height using the
8 height adjustment lever (18)
Lift the height of the cutting depth by one
notch using the 8 height adjustment lever (18)
Allow the grass to dry before mowing
Sharpen or replace the 4 x swing blades (30)
Stop mower and clear the rear discharge
chute (16)
Mower cannot be
pulled backward
Gearbox is engaged Release the self propelled engage/
disengage bar (2)
Self propel does not
operate
Gear box not engaged
Motor not operating
Fully lift self propelled engage/disengage
bar(2) against the top handle bar (1)
Start motor and retry
For issues relating specifically to the Briggs and Stratton engine, please contact
Briggs and Stratton via www.briggsandstratton.com or calling Customer Service
on (03) 9796 4900. For all other issues, please contact Customer Service on 1800 909 909
or email help@powertoolsupport.com
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline 49291 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline 49291 in the language / languages: English as an attachment in your email.

The manual is 2,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info