6 Troubleshooting
6.1 Introduction - troubleshooting
In this chapter you can find information and help about faults and symptoms of the product. You can find more
information and FAQ (Frequently Asked Questions) on www.gardena.com.
6.1.1 To get access to the Quick info menu
Technical data, values and information about the history
of the product can be found in the
Quick info
menu. If
you speak to GARDENA central service for a solution to
a problem, they can tell you to access the information
that is available in this menu.
• Push the Menu button for 3 seconds to enter the
Quick info
menu.
6.2 Fault messages
The fault messages in the table below are shown in the display of the product. Speak to your GARDENA
representative if the same message shows frequently.
Message Cause Action
Wheel motor
blocked, left/right
Grass or other object around the drive wheel. Remove grass or other object.
Cutting system
blocked
Grass or other object around the blade disc. Remove grass or other object.
The blade disc is in water. Move the product and prevent the collection
of water in the work area.
The grass is too high. Cut the grass before you install the product.
Make sure that the grass is maximum 4 cm /
1.6 in.
Trapped
The product is behind a number of obstacles
in a small area.
Remove the obstacles or put the boundary
wire around the obstacle to make an island.
Refer to
To make an island on page 17
.
Outside working area
A section of boundary wire is put across the
other section of boundary wire to the charg-
ing station.
Make sure that the boundary wire is connec-
ted correctly.
The boundary wire is too near the edge of
the work area.
Make sure that the boundary wire is installed
correctly. Refer to
To install the boundary
wire on page 20
.
The work area slopes much by the boundary
loop.
The boundary wire is put in the incorrect di-
rection around an island.
Interference to the boundary wire from metal
objects such as fences, reinforcement steel
or buried cables nearby.
Move the boundary wire.
The product cannot find the correct loop sig-
nal because of interference with a loop signal
from a different product installation nearby.
Put the product in the charging station and
generate a new loop signal.
38 - Troubleshooting 1298 - 015 - 20.08.2021
