Note: When the product cuts grass in the
secondary area, the
Secondary area
mode
must be selected. Refer to
Secondary area
on page 28
.
3.3.4 To examine where to put the guide
wire
• Put the guide wire in a line at a minimum of
2 m / 7 ft. in front of the charging station.
• Make sure that the guide wire has as much
free area as possible to the left of the guide
wire when facing the charging station. Refer
to
To set the corridor width of the guide wire
on page 18
.
• Put the guide wire minimum 30 cm / 12 in.
from the boundary wire.
• Do not make sharp bends when you install
the guide wire.
• If the work area has a slope, put the guide
wire diagonally across the slope.
3.3.4.1 To set the corridor width of the guide wire
The guide corridor is the area adjacent to the
guide wire, which the product uses to find the
charging station. When the product moves in the
direction of the charging station, it always moves
to the left of the guide wire.
1. Do steps 1–3 in
To get access to the menu
on page 22
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Advanced > Corridor width > Guide.
3. Use the number buttons to select a corridor
width of 0 to 9.
4. Push the BACK button.
Note: Make the corridor width as wide as
possible for a minimum risk of lines in the lawn.
18 - Installation 1025 - 001 - 23.01.2019
