687465

Gardena SILENO plus R160 Li-LiC Manual

43
Zoom out
Zoom in
Previous page
1/56
Next page
6 Troubleshooting
6.1 Introduction - troubleshooting
In this chapter, a number of messages are listed which may be shown in the display if there is a malfunction. There is
a proposal as to the cause and steps to take for each message. This chapter also presents some symptoms that can
guide you if the robotic lawnmower does not work as expected. More suggestions for steps to take in the event of
malfunction or symptoms can be found on www.gardena.com.
6.2 Fault messages
Below a number of fault messages are listed which may be shown in the display of the robotic lawnmower. Contact
your local GARDENA representative if the same message appears often.
Message Cause Action
Wheel motor blocked,
left
Grass or other object has wrapped around
the drive wheel.
Check the drive wheel and remove the grass
or other object.
Wheel motor blocked,
right
Grass or other object has wrapped around
the drive wheel.
Check the drive wheel and remove the grass
or other object.
Cutting system
blocked
Grass or other object has wrapped around
the blade disc.
Check the drive wheel and remove the grass
or other object.
The blade disc lies in a pool of water. Move the robotic lawnmower and prevent the
collection of water in the working area.
No loop signal
The power supply is not connected. Check the wall socket connection and wheth-
er an earth-fault breaker has tripped or not.
Check that the low voltage cable is connected
to the charging station.
The low voltage cable is damaged or not con-
nected.
Check that the low voltage cable is not dam-
aged. Check that it is also properly connected
to the charging station and to the power sup-
ply.
The boundary wire is not connected to the
charging station.
Check that the boundary wire connectors are
fitted properly to the charging station. Re-
place connectors if damaged. See
Connect-
ing the boundary wire on page 18
.
Boundary wire broken. Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler. See
Find breaks in the loop wire on page 48
.
ECO mode
is activated and the robotic lawn-
mower has attempted to start outside the
charging station.
Place the robotic lawnmower in the charging
station, press the START button and close
the hatch. See
Settings on page 29
.
The boundary wire is crossed on its way to
and from an island.
Check that the boundary wire is laid accord-
ing to instructions, e.g. in the right direction
around the island. See
Installation on page
26
.
The connection between the robotic lawn-
mower and the charging station has been
broken.
Place the robotic lawnmower in the charging
station and generate a new loop signal, see
New loop signal on page 26
.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
Try moving the boundary wire.
Trapped
The robotic lawnmower has got caught in
something.
Free the robotic lawnmower and rectify the
reason for it becoming trapped.
The robotic lawnmower is stuck behind a
number of obstacles.
Check if there are any obstacles which make
it hard for the robotic lawnmower to move on
from this location.
307 - 002 - 11.10.2017 Troubleshooting - 43
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardena SILENO plus R160 Li-LiC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardena SILENO plus R160 Li-LiC in the language / languages: English as an attachment in your email.

The manual is 7,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gardena SILENO plus R160 Li-LiC

Gardena SILENO plus R160 Li-LiC User Manual - German - 56 pages

Gardena SILENO plus R160 Li-LiC User Manual - Dutch - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info