4. Push the OK button.
3.10.3.2 To change the PIN-code
1. Do steps 1–3 in
To get access to the menu
on page 22
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> Security > Advanced > Change PIN-code
.
3. Enter the new PIN code.
4. Push the OK button.
5. Enter the new PIN code.
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3
.
3.10.4 SensorControl
Only for SILENO life and smart SILENO life.
The SensorControl automatically adjust the
cutting time to the growth of the grass. The
product is not permitted to operate more than the
schedule settings.
The first operation of the day is set by the
schedule settings. The product always complete
1 mowing cycle, and then the SensorControl
selects if the product will continue to operate or
not.
Note:
The SensorControl is reset if the product
stops to operate for more than 50 hours or if a
reset of all user settings. The SensorControl is
not changed if a Reset of schedule settings is
done.
3.10.4.1 To set the SensorControl
1. Do steps 1–3 in
To get access to the menu
on page 22
.
2. Use the arrow buttons and the OK button
to move through the menu structure
SensorControl > Use SensorControl
.
3. Push the OK button to select the
SensorControl.
4. Push the BACK button.
3.10.4.2 To set the SensorControl frequency
Set how frequently the product must cut the
grass when the SensorControl is in use. There
are 3 frequency levels: Low, Mid and High. The
higher the frequency, the longer the product is
allowed to work.
1. Do steps 1–3 in
To get access to the menu
on page 22
.
2. Use the arrow buttons and the OK button
to move through the menu structure
SensorControl > Cutting time
.
3. Use the arrow buttons to select
Low, Mid
or
High
frequency.
4. Push the BACK button.
3.10.5 Lawn Coverage
The Lawn Coverage function is used to guide the
product to remote parts of the work area.
You can divide your lawn into 3 areas.
3.10.5.1 To set the Lawn Coverage function
1. Do steps 1–3 in
To get access to the menu
on page 22
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> Lawn Coverage > Area 1-3
.
3. Use the arrow button to select the area.
4. Push the OK button.
5. Measure the distance from the charging
station to the start of the area. Measure
along the guide wire. Refer to
To measure
the distance from the charging station on
page 25
.
6. Push the arrow buttons to select the
distance, measured in m.
7. Push the OK button.
8. Use the arrow buttons to select the % of
the cutting time the product must cut the
area. The % is equal to the % of the area in
relation to the complete work area.
a) Measure the area.
b) Divide the area with the work area.
c) Convert the result to %.
24
- Installation
953 - 002 - 12.12.2018
