681414

Gardena R160LiC - smart SILENO plus Manual

71
Zoom out
Zoom in
Previous page
1/84
Next page
English - 70
TROUBLESHOOTING
Trapped
The robotic lawnmower has got
caught in something.
Free the robotic lawnmower and rectify the
reason for it becoming trapped.
The robotic lawnmower is stuck
behind a number of obstacles.
Check if there are any obstacles which make
it hard for the robotic lawnmower to move on
from this location.
Outside working area
The boundary wire connections to
the charging station are crossed.
Check that the boundary wire is connected
correctly.
The boundary wire is too close to the
edge of the working area.
Check that the boundary wire has been laid
according to the instructions. See 3 Installation
on page 15.
The working area slopes too much
by the boundary loop.
The boundary wire is laid in the
wrong direction around an island.
Disturbances from metal objects
(fences, reinforcement steel) or
buried cables close by.
Try moving the boundary wire.
The robotic lawnmower nds it hard
to distinguish the signal from an
installation close by.
Place the robotic lawnmower in the charging
station and generate a new loop signal,
see 6.4 Security on page 47.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and
the keypad is then blocked for ve
minutes.
Enter the correct PIN code. Contact
GARDENA Central Service if you forget the
PIN code. See MEMO on page 2.
No drive
The robotic lawnmower has got
caught in something.
Free the robotic lawnmower and rectify the
reason for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before
using the robotic lawnmower.
The working area includes a steep
slope.
Maximum guaranteed slope is 35%. Steeper
slopes should be isolated. See 3.4 Installation
of the boundary wire on page 21.
The guide wire is not laid at an angle
on a slope.
If the guide wire is laid on a slope, it must be
laid at an angle across the slope. See 3.6
Installation of the guide wire on page 28.
Wheel motor
overloaded, right
The robotic lawnmower has got
caught in something.
Free the robotic lawnmower and rectify the
reason for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before
using the robotic lawnmower.
Wheel motor
overloaded, left
Charging station
blocked
The contact between the charging
strips and contact strips may be poor
and the robotic lawnmower has made
a number of attempts to charge.
Put the robotic lawnmower in the charging
station and check that the charging strips
and contact strips make good contact.
An object is obstructing the robotic
lawnmower.
Remove the object.
Stuck in charging
station
There is an object in the way of the
robotic lawnmower preventing it from
leaving the charging station.
Upside down
The robotic lawnmower is leaning too
much or has turned over.
Turn the robotic lawnmower the right way up.
1157808,Gardena_R100Li-R130Li,GB_151217.indd 70 2016-01-12 09:17:09
… 71 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardena R160LiC - smart SILENO plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardena R160LiC - smart SILENO plus in the language / languages: English as an attachment in your email.

The manual is 14,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gardena R160LiC - smart SILENO plus

Gardena R160LiC - smart SILENO plus User Manual - German - 64 pages

Gardena R160LiC - smart SILENO plus User Manual - Dutch - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info