672939
76
Zoom out
Zoom in
Previous page
1/84
Next page
English - 75
TROUBLESHOOTING
9.5 Finding breaks in the loop wire
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such as when gardening with
a shovel. In countries with ground frost, also sharp stones that move in the ground can damage the wire. Breaks can
also be due to the wire being stretched excessively during installation.
Mowing the grass too low right after the installation can damage wire insulation. Certain damage to the insulation may
not cause disruptions until several weeks or months later.
A defective splicing of the loop wire can also lead to disruptions rst several weeks after the splice was done. A faulty
splice can, for example, be the result of the original coupler not being pressed together hard enough with a pair of
pliers, or that a coupler of lower quality than the original coupler has been used. Please rst check all known splices
before further troubleshooting is done.
A wire break can be located by gradually halving the distance of the loop where the break may have occurred until
there is only a very short section of the wire left.
The following method does not work if ECO mode is activated. Make sure rst that ECO mode is turned off. See 6.8
Settings on page 56.
1. Check that the indicator lamp in the charging
station ashes blue, which indicates a break in
the boundary loop. See 9.3 Indicator lamp in the
charging station on page 73.
2. Check that the boundary wire connections to the
charging station are properly connected and not
damaged. Check that the indicator lamp in the
charging station is still ashing blue.
3. Switch the connections between the guide wire
and the boundary wire in the charging station.
a) Switch connection AL and G1.
If the indicator lamp is lit with a solid green light,
then the break is somewhere on the boundary
wire between AL and the point where the guide
wire is connected to the boundary wire (thick black
line in the illustration).
3018-216
POWER
AR
AL
G
3018-224
Guide
G1
AL
3018-225
1157808,Gardena_R100Li-R130Li,GB_151217.indd 75 2016-01-12 09:17:11
76


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardena R130Li Sileno at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardena R130Li Sileno in the language / languages: English as an attachment in your email.

The manual is 14,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gardena R130Li Sileno

Gardena R130Li Sileno Quick start guide - German - 4 pages

Gardena R130Li Sileno User Manual - German - 64 pages

Gardena R130Li Sileno User Manual - Dutch - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info