672935
7
Zoom out
Zoom in
Previous page
1/13
Next page
16
GB
Probable cause
Rotary switch is not turned to
RUN.
The pump is sucking air through
a leak at a connection on the
suction side.
Pump is not adequately primed
with the liquid to be pumped.
Air cannot escape on the pres-
sure side, because the pressure
side outlets are closed.
End of the suction hose is not in
the water, the non-return valve
at the end of the suction hose is
missing or leaking, the suction
hose is kinked, connections are
leaking or the suction filter is
blocked.
Mains plug not plugged in.
Power failure.
Pump impeller is jammed.
Overheating due to running dry
or water temperature too high
(Thermal overload switch has
switched the pump off).
Problem
The pump sucks nothing up.
Pump motor does not start
or stops suddenly during
operation.
Remedy
Refill pump and turn rotary
switch to RUN.
Check all connections and
make them air-tight as
necessary.
Prime the pump
(see 4. Operation).
Open the pressure side
outlets.
Check the complete suction
hose from suction point
through to the pump for leak-
tightness and repair any
leaks as necessary.
Insert mains plug into a
mains socket (230 V AC).
Check fuse and cables.
Turn the pump impeller motor
shaft with a screwdriver to
free it.
Check the water level at the
suction side.
The maximum temperature of
the liquid conveyed should
be (35 °C).
7. Troubleshooting
DANGER ! Electric shock !
Unplug the cable at the mains before trouble-shooting.
Cleaning the check valve: 1. Unplug the pump from the mains.
2. Turn the Pressure Tank Unit upside down.
3. Turn the rotary switch
to FILL.
4. If necessary close all the suction side inlets.
5. Open all pressure side outlets, so that the pressure side is
depressurised.
6. Unscrew the drain screw
and drain the water.
7. Undo screw
and slide the clip
upwards 1 and to the rear
2 into the bearing groove.
8. Using a suitable tool, unscrew the check valve cover
.
9. Remove the valve body
and wash it under running water.
10. Reassemble the check valve in the reverse order.
11. Switch the Pressure Tank Unit back on again
(see 4. Operation).
2
1
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardena 1774 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardena 1774 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info