Manual Gallagher M300 (page 5 of 74) (English, German, Dutch, Danish, French, Italian, Swedish, Spanish)

699091

Zoom out

Zoom in

1/74

English

Important Informa on

IMPORTANT INFORMATION

WARNING: Read all instrucƟ ons

• Do NOT touch the fence with the head, mouth, neck or torso. Do not climb over, through or under a

mul -wire electric fence. Use a gate or a specially designed crossing point.

• Do NOT become entangled in the fence. Avoid electric fence construc ons that are likely to lead to the

entanglement of animals or persons.

• Energizer must be installed in a shelter and the supply cord must not be handled when the ambient

mperature is below +5 deg C.

• Ensure the Energizer is fully protected from rain, condensa on and other sources of moisture.

• Do not mount in places exposed to heat sources (e.g. a sun heated metal wall.)

• Ensure the Energizer has adequate ven la on.

• Electric animal fences shall be installed and operated so that they cause no electrical hazard to persons,

animals or their surroundings.

• It is recommended that, in all areas where there is a likely presence of unsupervised children who will be

unaware of the dangers of electric fencing, that a suitably rated current limi ng device having a resistance

of not less than 500 ohms be connected between the energizer and the electric fence in this area.

• The appliance is not intended for use by young children or inﬁ rm persons without supervision.

• Young children should be supervised to ensure that they do not play with the appliance.

• Do not place combus ble materials near the fence or energizer connec ons. In  mes of extreme ﬁ re risk,

disconnect energizer.

• Regularly inspect the supply cord and energizer for any damage. If found damaged in any way,

immediately cease use of the energizer and return it to a Gallagher Authorised Service Centre for repair in

order to avoid a hazard.

• Refer servicing to a Gallagher Authorised Service Centre.

• Check your local council for speciﬁ c regula ons.

• Energizers with a Standby mode may turn on or oﬀ without warning. The energizer must be disconnected

from the mains supply if it needs to be rendered fully inopera ve.

• An electric animal fence shall not be supplied from two separate energizers or from independent fence

circuits of the same energizer.

• For any two separate electric animal fences, each supplied from a separate energizer independently  med,

the distance between the wires of the two electric animal fences shall be at least 2.5m. If this gap is to be

closed, this shall be eﬀ ected by means of electrically non-conduc ve material or an isolated metal barrier.

• Do not connect two Energizers to the same earth system.

• Barbed wire or razor wire shall not be electriﬁ ed by an energizer.

• A non-electriﬁ ed fence incorpora ng barbed wire or razor wire may be used to support one or more

oﬀ -set electriﬁ ed wires of an electric animal fence. The suppor ng devices for the electriﬁ ed wires shall

be constructed so as to ensure that these wires are posi oned at a minimum distance of 150 mm from

the ver cal plane of the non-electriﬁ ed wires. The barbed wire and razor wire shall be earthed at regular

intervals.

• Follow the energizer manufacturer’s recommenda ons regarding earthing.

• The energizer earth electrode should penetrate the ground to a depth of at least 1 m (3  ) and not be

within 10 m (33  ) of any power, telecommunica ons or other system.

• Use high voltage lead-out cable in buildings to eﬀ ec v

ely insulate from the earthed structural parts of the

building and where soil could corrode exposed galvanized wire. Do not use household electrical cable.

• Connec ng leads that are run underground shall be run in conduit of insula ng material or else insulated

high voltage lead-out cable shall be used. Care must be taken to avoid damage to the connec ng leads due

to the eﬀ ects of animal hooves or tractor wheels sinking into the ground.

• Connec ng leads shall not be installed in the same conduit as the mains supply wiring, communica on

cables or data cables.

• Connec ng leads and electric animal fence wires shall not cross above overhead power or communica on

lines.

• If connected to a mains power circuit that doesn’t have a Residual Current Device (RCD), then a plug-in

RCD should always be used.

• Crossings with overhead power lines shall be avoided wherever possible. If such a crossing cannot be

avoided it shall be made underneath the power line and as nearly as possible at right angles to it.

• If connec ng leads and electric animal fence wires are installed near an overhead power line, the

clearances shall not be less than those shown in the table following.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gallagher M300 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 3,32 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gallagher M300 Manual

Product: