544813

Gaggia RI8151 Cubika Plus Manual

12
Zoom out
Zoom in
Previous page
1/49
Next page
ENGLISH
Making hot water:
1. Follow the procedure described under
Preparation.
2. Turn the power switch (1) to 1.
3. Allow about 6 minutes for the machine to reach
its proper operating temperature.
4. Place a pitcher under the steam pipe (8).
2 Position steam switch (4) to 1.
3 After 15 to 20 seconds or, when temperatu-
re ready-light (3) goes on, place the frothing
pitcher halffilled with low-fat milk under Tur-
bo Frother steam nozzle so that tip is just
under the surface of the milk. See Fig.3.
4 Slowly turn steam valve knob (7) counter
clockwise to release steam.
IMPORTANT. The more you turn the knob,
the greater the steam pressure for frothing.
N.B.: Dispensing should not exceed 60
seconds.
5 Move pitcher in circular motion keeping the
tip of steam nozzle just under surface of milk
as it begins to froth. Do not let milk come to
a boil since it will not froth.
6 When you have made enough froth,turn
steam knob clockwise to shut off steam and
remove pitcher. Put steam switch (4) to pos.
0.
7 Spoon the froth onto the espresso in each
cup and gently pour the hot milk along the
side of the cup. Top each cup of cappucci-
no with a dash of cinnamon, cocoa and
nutmeg. Serve.
8 NOTE: If you want to make more espresso
immediately after steaming milk, the
machine boiler must be refilled with water
and temperature brought down to a brewing
temperature. Otherwise, espresso may taste
burned. To do this: place an empty cup
on drip plate.
Do not insert filter holder. Turn hot water/
brew switch (4) to 1letting cup fill with
water. Turn brew switch 0. You many now
proceed to make more espresso.
5 Slowly turn steam valve knob (7) counter
clockwise and turn the hot water/brew switch
to 1to release hot water.
N.B.: Dispensing should not exceed 60
seconds.
6 When you have prepared the desired
quantity of hot water, turn steam knob
clockwise and hot water/brew switch to 0
to shut off hot water and remove pitcher.
7 NOTE: If you want to make espresso
immediately after making hot water, the tem-
perature of the machine boiler must be
brought down to a brewing temperature.
Otherwise, espresso may taste burned.
To do this: place an empty cup on drip plate.
Do not insert filter holder. Turn hot water/
brew switch (2) to 1letting cup fill with
water. Turn brew switch 0.
You may now proceed to make espresso.
Keeping it clean:
1 IMPORTANT: the steam nozzle should be
cleaned after each use in order to avoid
build up of milk deposits that are very difficult
to clean.
The outside of the steam pipe can be cleaned
with a damp cloth.
The steam jet is cleaned by running a shot
of steam through it.
The hole in the steam nozzle must be kept
open. A needle may be used.
2 Clean filter holder and filter in warm water
after use.
 12 
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggia RI8151 Cubika Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggia RI8151 Cubika Plus in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info