3588
2
Zoom out
Zoom in
Previous page
1/53
Next page
FIG.01
1
2
3
4
5
6
7
La prima volta che usate il pannarello, dovete ...
The first time you use the frother, you must...
Bei erstmaliger Verwendung des Schaumschlägers müssen Sie ….
La première fois que vous utilisez le mixeur, il faut.....
La primera vez que usa el esquema, siga las instrucciones que se detallan a continuación
De eerste keer dat u het stoompijpje voor het opschuimen van melk gebruikt, moet u .....
Quando se usa o bico pela primeira vez, deve-se ...
I
- Infilare la Ghiera filettata 1 sul tubo vapore.
- Inserire il gommino 3 nell’Iniettore 4, inserire il Premi-
gommino 2 sopra al Gommino 3, calzare l’assieme 2-
3-4 sul tubo vapore.
- Avvitare la Ghiera 1 sull’Iniettore 4. Serrare 5.
- Inserire il canotto esterno 6 come in figura.
- Il canotto interno 7 va montato correttamente, facen-
do sporgere la parte inferiore dal canotto esterno,
come evidenziato nella figura.
GB
- Slide the Ring Nut 1 onto the steam hose.
- Place the Gasket 3 into the Injector 4, and place the
Gasket Press 2 over the Gasket 3. Slide the assembly
2-3-4 over the steam hose.
- Screw the Ring Nut 1 onto the Injector 4. Tighten 5.
- Attach the external housing 6 as shown in the Figure.
- The internal sleeve 7 must be correctly installed, by
protruding the lower part of the external sleeve, as
shown in figure.
F
- Glisser la douille filetée 1 sur le tuyau de la vapeur.
- Insérer le caoutchouc 3 dans l’injecteur 4, insérer le
presse-caoutchouc 2 sur le caoutchouc 3, emmancher
l’ensemble 2-3-4 sur le tuyau de la vapeur.
- Visser la douille 1 sur l’injecteur 4. Serrer 5.
- Insérer le manchon externe 6 comme il est indiqué sur la figure.
- Le manchon intérieur 7 doit etre installé de la façon
correcte, en laissant dépasser la partie inférieure du
manchon extérieur, comme indiqué par la figure.
D
- Gewindenutmutter auf Dampfrohr aufsetzen.
- Gummiring 3 in Düse 4 einsetzen, Gumminiederhalter 2
auf Gummiring 3 aufsetzen, Komplex 2-3-4 in Dampfrohr
einführen.
- Gewindenutmutter 1 auf Düse 4 schrauben.
Festschrauben 5.
- Außenbüchse 6 gemäß Abbildung einfügen.
- Das innere Rohr 7 ist korrekt anzubringen, wobei der
untere Teil des Außenrohrs herausragt, wie es auf
Abbildung zu ersehen ist.
P
- Enfie o casquilho roscado no tubo de vapor.
- Introduza a borracha 3 no injector 4. Introduza o
pressionador da borracha 2 por cima da borracha 3; a
seguir introduza o grupo 2-3-4 no tubo de vapor.
- Enrosque o casquilho roscado 1 no injector 4.
- Introduza o canote externo 6 como ilustrado na figura.
- O pequeno tubo interno 7 deve ser montado
corretamente, fazendo sair a parte inferior do pequeno
tubo externo, como evidenciado na figura.
NL
- Schuif de getapte sluitring op het stoompijpje.
- Schuif het rubbertje 3 in het spuitstuk 4, schuif de
rubberhouder 2 op het rubbertje 3, zet het geheel 2-3-
4 op het stoompijpje.
- Draai het einddopje 1 op het spuitstuk 4.
- Bevestig het buitenste mondstuk 6 op het spuitstuk,
volgens de afbeelding.
- De binnenste schuif 7 wordt op de juiste manier gemonteerd
door het onderste gedeelte van de buitenste schuif uit te
laten steken zoals getoond wordt in figuur.
E
- Introduzca el casquillo roscado 1 en el tubo de vapor.
- Introduzca la empaquetadura de anillo 3 en el inyector
4, introduzca el aprieta-empaquetadura 2 en la
empaquetadura 3. Acto seguido, ubique el grupo 2-3-
4 en el tubo de vapor.
- Enrosque el casquillo roscado 1 en el inyector 4.
Enroscar hasta el tope 5.
- Introduzca el forro exterior 6 como se aprecia en la figura.
- Monte correctamente el tubo interior 7, sobresaliendo
el lado inferior del tubo exterior, como señalado en la
figura.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggia Evolution at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggia Evolution in the language / languages: Dutch as an attachment in your email.

The manual is 2,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gaggia Evolution

Gaggia Evolution User Manual - English, German, Dutch, French, Italian, Portuguese, Spanish - 53 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info