762999
2
Zoom out
Zoom in
Previous page
1/8
Next page
de
Ø Montageanleitung
Das müssen Sie beachten
Elektrischer Anschluss
Das Gerät darf nur an eine vorschriftsmäßig installierte Schutz-
kontakt-Steckdose angeschlossen werden. Das Verlegen einer
Steckdose oder Austausch der Anschlussleitung darf nur vom
Elektrofachmann unter Berücksichtigung der einschlägigen Vor-
schriften ausgeführt werden.
Das Gerät darf nur mit der mitgelieferten Anschlussleitung
angeschlossen werden. Stecken Sie die Anschlussleitung an
der Geräterückseite an.
Anschlussleitungen mit verschiedenen Steckertypen sind beim
Kundendienst erhältlich.
Keine Mehrfachstecker, Steckerleisten und Verlängerungen
benutzen. Bei Überlastung besteht Brandgefahr.
Wenn der Stecker nach dem Einbau nicht mehr erreichbar ist
muss installationsseitig eine allpolige Trennvorrichtung mit
einem Kontaktabstand von mind. 3 mm vorhanden sein.
Einbaumöbel
Der Einbauschrank darf hinter den Geräten keine Rückwand
haben. Zwischen Wand und Schrankboden bzw. Rückwand des
darüberliegenden Schrankes muss ein Abstand von mind.
45 mm eingehalten werden.
Die Lüftungsschlitze und Ansaugöffnungen dürfen nicht verdeckt
werden.
Hierzu auch die Montageanleitung des darüberliegenden Gerä-
tes beachten.
Einsetzen des Gerätes
Schließen Sie das Gerät an. Gerät bündig im Möbel ausrichten
und festschrauben.
Hinweis: Achten Sie darauf, dass die Anschlussleitung nicht ein-
geklemmt oder geknickt wird.
Die Anschlussleitung darf nach dem Einbau die Rückseite und
den Boden des Gerätes nicht berühren.
en
Ú Installation instructions
Please observe
Electrical connection
The appliance must only be connected to a properly installed
protective contact socket. The installation of the socket or
replacement of the connecting cable must only be carried out
by a qualified electrician in accordance with current regulations.
The appliance must only be connected with the power cable
provided. Connect the power cable to the back of the appliance.
Power cables with various plug types are available from our
after-sales service.
Do not use multi-plug adapters, power strips or extension leads.
There is a risk of fire in the event of overloading.
If the plug is no longer accessible subsequent to installation, an
all-pole disconnecting device must be present on the installation
side with a contact gap of at least 3 mm.
Fitted units
There must be no rear wall to fitted units which house
appliances. There must be a gap of at least 45 mm between the
wall and the base of the unit, as well as between the wall and
the rear wall of theunit above.
The ventilation slots and air intake points must not be covered.
To ensure that they remain uncovered, also observe the
installation instructions for the appliance above.
Installing the appliance
Connect the appliance to the mains. Then align the appliance
flush with the units and screw it in place.
Note: Ensure that the connector lead does not become trapped
or bent. After installation, the connector lead must not be in
contact with the back or the base of the appliance.
After installation, the connector lead must not be in contact with
the back or the base of the appliance.
PP
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggenau WSP221130 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggenau WSP221130 in the language / languages: All languages as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info