760884
21
Zoom out
Zoom in
Previous page
1/36
Next page
20
en Locking the control panel for cleaning
Setting procedure
Select the appropriate temperature level from the table.
Set an empty item of cookware down on the cooking
zone.
1Use the control knob to select the temperature
setting you require. Temperature settings 1to 5are
available for this function; see temperature settings
table.
2Touch the Ú symbol; it will be lit orange.
and the temperature setting you have selected
will be lit.
The function has now been activated.
The ¬, « or ª temperature indicator and the
temperature setting you have selected will remain lit
until the frying temperature has been reached. An
audible signal will then sound and the temperature
indicator will go out.
3Once the frying temperature has been reached, add
the fat and then the food to the pan.
Notes
If a temperature setting above 5is selected,
setting will automatically be set. In this case, turn
the control knob to position 5.
Turn the food so that it does not burn.
Switching off the frying sensor
Turn the control knob that was used to select the
temperature to position 0. The hotplate will switch off
and the residual heat indicator will appear.
A
Locking the control panel for cleaning
Locking the control panel for cleaning
Wiping over the control panel while the hob is switched
on may alter the settings. To avoid doing this, you can
use the hob's "Lock control panel for cleaning" function.
To switch on: Touch the symbol. An audible signal
will sound. The indicators for the active functions will
flash. The control panel will be locked for 10minutes.
You will now be able to clean the surface of the control
panel without altering the settings.
To switch off: Touch the symbol again within the next
10minutes.
If the function is not deactivated within these
10minutes, the hob will switch itself off.
Notes
The locking function does not affect the control
knobs.The hob can be switched off at any time.
While the locking function is active, the power
supply to the hob is disconnected. The hotplates
may still be hot.
b
Automatic safety switch-off function
Automati c safety swi tch-off functi on
For your protection, the appliance features a safety
switch-off function. Depending on which heat setting
has been selected, the hotplate's heating element will
be deactivated if no further action is performed within a
set time after selecting the heat setting.
An audible signal will indicate when this time has
elapsed. The control knob is active and the illuminated
ring around it will flash. ”‰ will be lit on the hotplate
display.
Turn the control knob to position 0. The appliance can
now be switched back on as usual.
 
Heat setting Deactivated after
10hours
ƒ to 5hours
to ˆ4hours
3hours
Š to ‚‹ 2hours
‚‚ to ‚ƒ 1hour
Frying sensor temperature setting Deactivated after
to 3hours
21
Basic settings en
Q
Basic settings
Basic setti ngs
The appliance has various basic settings. These basic
settings can be altered to suit your individual
requirements.
Notes
The ™†, ™‡, ™ˆ and ™‰ settings are only
displayed if the appliance is connected to an
extractor hood.
The ™ˆ and ™‰ settings are only displayed if the
appliance is connected to an extractor hood with
lighting.
To access the basic settings:
The hob must be off.
1Carry out the following operating steps one after
the other without interruption.
2Push in one of the control knobs and turn it anti-
clockwise to Ž. Keep the control knob pressed in.
3Turn the control knob clockwise to position 1. Keep
the control knob pressed in.
4Turn the control knob anti-clockwise to position 0.
The t symbol will be lit. The illuminated ring
around the control knob will be lit yellow.
Display Function
™‚ Signal tones
‹¯ All signal tones activated.*
‹”” Only fault signal activated.
™ƒ Power management function. Limit the total
power of the hob (watts)
‹”” Deactivated.*
‚‹‹‹ Lowest setting
‚†‹‹
ƒ‹‹‹
...
Š†‹‹ Highest setting on the hob
™„ Check cookware; cooking results
Not suitable
Not ideal
ƒSuitable
™… Restore standard settings
‹”” Individual settings.*
‹¯ Restore factory settings.
™† Automatic fan start-up
‹”” Switched off.
The extractor hood must be switched on manually,
if required.
Switched on in automatic mode.*
In automatic mode, the extractor hood switches
itself on when you switch on one of the cooking
zones.
/ƒ/Switched on in manual mode.
The extractor hood switches itself on at a fixed fan
setting when you switch on any of the cooking
zones.
* Basic setting
™‡ Fan run-on
‹”” The fan switches itself off when the hob is
switched off.
Not recommended for the extractor hood in air cir-
culation mode
¥Fan run-on in automatic mode.*
¯‹ Fan run-on with the most recently selected setting.
™ˆ Automatic switch-on of extractor hood lighting
‹”” Switched off.*
‹¯ Switched on.
The light switches itself on when the hob is
switched on.
™‰ Automatic switch-off of extractor hood lighting
‹”” Switched off.*
The light switches itself off when you switch off the
hob.
‹¯ Switched on.
The light switches itself on when you switch off the
hob.
¥—¯ Switched on.
The light switches itself on when the fan runs on
and goes out when the fan run-on time ends.
Display Function
* Basic setting

21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggenau VI 462 103 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggenau VI 462 103 in the language / languages: English as an attachment in your email.

The manual is 2,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gaggenau VI 462 103

Gaggenau VI 462 103 User Manual - German - 36 pages

Gaggenau VI 462 103 User Manual - Dutch - 36 pages

Gaggenau VI 462 103 User Manual - French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info