Preparing the cabinet
• Cut out the recess for the hob in your worktop.
Proceed as indicated on the installation sketch.
The installation sketch contains the measurements
of the space required for the trim between the
appliances. Several appliances can also be
installed in individual recesses, as long as a
minimum clearance of 50 mm is kept to between
the appliances.
• As shown in the installation sketch, drill the
Ø35mm holes to secure the control knobs in the
cabinet front.
• If the cabinet front is thicker than 26 mm, the front
must be routed from the back to max. 26 mm on
an area of 80 x 310 mm.
• It is possible to install the appliance above a
ventilated built-in oven. Observe the installation
instructions. Remove the rear wall of the kitchen
cabinet to ensure air circulation of the appliance.
Leave a ventilation gap of 20 mm behind the oven
or the kitchen cabinet and the wall.
14
min. 5
min. 5