20
Installing the Spindles
The numbers correspond to the diagram on the
opposite page. Spindle extensions (SV 402-090 /
SV 402-205) are available should the appliance be
installed in a worktop which is non-standard depth.
Loosen the nuts of the spindle covers and remove
covers.
1 Insert the spindles from behind into the fittings of
the control knobs. Be careful that the broader pin
of the control knob fits the broader fitting of the
spindle.
2 The gas taps of the burners must be in the off
position (flat side to the top). Slide the spindles
on the gas taps.
3 Fix the spindles with the screws provided.
Turn the control knob to the off position. Connect
the appliance to the power supply, and check for
correct functioning. If the appliance switches off
there may be air in the gas supply line. Turn the
control knobs to the off position and relight. This
may need to be repeated until the appliance
ignites.
