123577
14
Zoom out
Zoom in
Previous page
1/23
Next page
14
Switching the dishwasher OFF
Several minutes after the programme has ended:
Open the door when the programme has ended.
Set main switch
1
to OFF.
Turn the water tap off.
(Does not apply when Aqua-Stop unit has been
fitted)
Remove dishes, etc. when they have cooled down.
Interrupting the programme
Open the door. Caution! There is a risk of water
squirting out from inside the appliance. Do not open
the door fully until the spray arm has stopped
rotating.
Set main switch
1
to OFF.
Indicator lights extinguish. The programme is
retained in the dish- washer memory.
If the hot water was switched ON or the appliance has
already heated up and then the appliance door opened,
leave the door ajar for several minutes and then close.
Otherwise, the appliance door may fly open due to
expansion.
In order to continue with the stored programme, set
the main switch to ON again and close the door.
Terminating the programme (Reset)
Simultaneously press programme buttons A
and
C for approx. 3 sec.
The numerical display indicates
.
Close the door.
The programme sequence lasts approx. 1 min.
Switch off the main switch
1
.
Changing the programme
When the appliance is switched on, the programme
can be changed within minutes.
If the programme is changed subsequently, programme
sections (e.g. Cleaning) which have already started run
to the end. The new remaining time consists of the
remaining time of the previous programme section
and the remaining time of the newly selected
programme.
Intensive drying
In the final rinse the appliance operates at a higher
temperature and therefore an improved drying result is
obtained. (Caution if utensils are fragile!)
Hold down programme button A and press main
switch until
1
the digital display illuminates.
Release both buttons.
The LED for button
A flashes and the digital display
8
displays the factory setting (off) or (on).
To change the setting, press programme button A .
Switch off the main switch
1
.
Additional functions
* not included with all models
Soaking *
The soaking cycle runs before the main programme
and must be selected before
the programme starts. In
this additional programme cooking utensils, e.g. pans,
bowls, etc., can be soaked and prerinsed in the
bottom basket.
It is recommended to put approx. 5 g of detergent on
the door.
Turbo *
The programme running time is reduced significantly in
the Turbo programme. The energy consumption is
increased by up to 30% due to more intensive heating.
The time reduction affects the following programmes:
Intensive: Time reduction up to
25 %
Auto: Time reduction up to 25 %
Eco: Time reduction up to 58 %
Top basket washing only *
If there are only a few utensils (e.g. glasses, cups,
plates), use the top basket. The bottom basket must be
empty!
Use slightly less detergent than is recommended for a
complete load.
Bottom basket washing only *
If there are only a few utensils (e.g. plates, pans,
bowls), use the bottom basket. The top basket must be
empty!
Use slightly less detergent than is recommended for a
complete load.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggenau di 461-110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggenau di 461-110 in the language / languages: English as an attachment in your email.

The manual is 3,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gaggenau di 461-110

Gaggenau di 461-110 User Manual - German - 23 pages

Gaggenau di 461-110 User Manual - Dutch - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info