19
Fresh water connection
Using the enclosed parts, connect the fresh water
connection to the tap according to the installation
instructions. Ensure that the fresh water connection is
not kinked, crushed or twisted.
When replacing the appliance, always connect a new
water supply hose to the water supply. The old supply
hose must not be re-used.
Water pressure:
Minimum 0,05 MPa (0,5 bar) – maximum 1 MPa (10
bar).
If the water pressure is higher, install a pressure
reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water.
If you do use hot water, the temperature should not
exceed 60 °C.
Electrical connection
Connect the appliance only to 230 V alternating current
via a correctly installed socket with protective
conductor.
See rating plate for required fusing
31 .
The socket must be attached near the dishwasher and
be freely accessible.
The connection may be modified by an electrician only.
Use only a residual-current-operated circuit-breaker
which features the
symbol. Only this circuit breaker
guarantees compliance with the currently valid
regulations.
Removing the appliance
It is essential, when removing the appliance, to observe
the following sequence: First, disconnect the appliance
from the power supply.
Pull out the mains plug.
Turn off the water supply.
Disconnect the waste water and fresh water
connections.
Loosen the fastening screws under the worktop. If
fitted, remove the base panel.
Pull out the appliance, carefully pulling the hose
behind.
Transporting the dishwasher
Drain water from the dishwasher. Secure all loose
parts. The appliance should only be transported in an
upright position.
If the appliance is not kept upright during transport,
any water left inside may seep into the control
module and cause subsequent errors with
programme functions.
The appliance must be drained in the following
sequence:
Turn on the tap.
Set main switch to ON.
Select the B programme. The programme
duration in minutes is shown in the numerical
display.
Close the door.
Wait for approximately 4 minutes.
Terminate the programme by pressing A and
C simultaneously.
The time display changes to .
Close the door.
Wait a further minute and then switch the
appliance off.
Turn off the tap.
Protection from freezing temperatures
If the appliance is installed in a location where there is
a risk of freezing temperatures (e.g. in a holiday home),
all water must be completely drained out of the interior
(see “Transporting the dishwasher”).
Turn OFF the tap, disconnect the supply hose and
allow to drain.
