22
Waste water pump
Large food remnants or foreign objects which were
not captured by the filters may block the waste water
pump. The rinsing water will then be above the filter.
In this case:
1 First always disconnect the appliance from the
power supply.
2 Take out top basket 1* and bottom basket 9*.
3 Remove the filters 1j.
4 Scoop out water, use a sponge if required.
5 Prise out the white pump cover (as illustrated)
using a spoon. Grip the cover on the crosspiece
and lift diagonally inwards. Remove cover
completely.
6 Check impeller wheel and remove any foreign
objects.
7 Place cover in the original position and press
down until it engages (click).
8 Install filters.
9 Re-insert baskets.
... when the appliance is
switched on
The appliance does not start.
The mains fuse has tripped.
The appliance plug has not been inserted.
The appliance door has not been shut properly.
... changing settings
A setting cannot be changed, a programme
starts.
Wrong programme button pressed. Terminate the
programme (see chapter entitled “Terminating the
programme (Reset)”) and start all over again.
You did not wait until programme ended.
... on the appliance
Lower spray arm rotates sluggishly.
Spray arm blocked.
The door is difficult to open. *
Child-proof lock is activated. The deactivation
instructions are at the back in the envelope.
* depending on model
Door cannot be closed.
Door lock has been activated. To reset, close the
door with greater force.
Cover on the detergent dispenser cannot be
closed.
Detergent dispenser overfilled or mechanism
blocked by sticky detergent residue.
Detergent residue in the detergent dispenser.
Dispenser was damp when filled.
“Check water supply” display @ lights up.
Tap turned off.
Water supply interrupted.
Supply hose kinked.
