24
Installation
The dishwasher must be connected by a qualified
technician to ensure correct operation. The
specifications for supply, drainage and connected load
must fulfil the required criteria as stated in the following
paragraphs or in the installation instructions.
Install the appliance in the following sequence:
– Check the delivery
– Install the appliance
– Connect the waste water
– Connect the fresh water
– Connect the power supply
Delivery
Your dishwasher was checked at the factory to ensure
that it was in perfect working order. This may have left
some small water stains in the dishwasher. These will
disappear after the first rinse cycle.
Installation
The required installation dimensions can be found in
the installation instructions. Using the height-adjustable
feet, adjust the appliance until it is level. Ensure that
the appliance is standing firmly.
Waste water connection
See the installation instructions for the required
connection steps. If required, attach a siphon with
drainage spigot. Using the enclosed parts, connect the
waste water hose to the drainage spigot of the siphon.
Ensure that the drainage hose is not kinked, crushed or
twisted (ensure that there is no sealing cover which
prevents the waster water from flowing away!).
Fresh water connection
Using the enclosed parts, connect the fresh water
connection to the tap according to the installation
instructions. Ensure that the fresh water connection is
not kinked, crushed or twisted.
When replacing the appliance, always connect a new
water supply hose to the water supply. The old supply
hose must not be re-used.
Water pressure:
Minimum 0,05 MPa (0,5 bar) – maximum 1 MPa (10
bar).
If the water pressure is higher, install a pressure
reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water.
If you do use hot water, the temperature should not
exceed 60 °C.
Electrical connection
Connect the appliance only to 230 V alternating current
via a correctly installed socket with protective
conductor.
See rating plate for required fusing
32 .
The socket must be attached near the dishwasher and
be freely accessible.
The connection may be modified by an electrician only.
Use only a residual-current-operated circuit-breaker
which features the
symbol. Only this circuit breaker
guarantees compliance with the currently valid
regulations.
Removing the appliance
It is essential, when removing the appliance, to observe
the following sequence: First, disconnect the appliance
from the power supply.
Pull out the mains plug.
Turn off the water supply.
Disconnect the waste water and fresh water
connections.
Loosen the fastening screws under the worktop. If
fitted, remove the base panel.
Pull out the appliance, carefully pulling the hose
behind.
Transportation
Empty the dishwasher according to the following steps:
Turn on the tap.
Switch on the appliance.
Start any automatic programme and close the
appliance door.
Wait until approx. 4 minutes have elapsed.
Then open the door, terminate the programme and
close the door to drain the appliance.
Wait until the buzzer is emitted 5 times, i.e. all the
water has been drained.
Switch off the appliance.
Turn off the tap.
Secure loose parts prior to transportation.
Transport the appliance upright only. Otherwise,
residual water may penetrate the control and damage
the appliance.
Protection from freezing temperatures
If the appliance is installed in a location where there is
a risk of freezing temperatures (e.g. in a holiday home),
all water must be completely drained out of the interior
(see “Transporting the dishwasher”).
Turn OFF the tap, disconnect the supply hose and
allow to drain.
