16
Optical display while the
programme is running *
* depending on model
While the programme is running, a light spot shines
on the floor under the appliance door. Do not open
the dishwasher door until the light point is no longer
visible on the floor.
If the appliance is installed at eye-level, with flush
furniture front, the light point is not visible.
This function can be changed as follows:
1 Open the door.
2 Switch on ON/OFF switch (.
3 Hold down programme button # and press
START button )" until •:‹.... is indicated on the
digital display.
4 Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factory setting •:‹….
5 Press programme button # until the factory set
value ‚:‹‚ is indicated on the digital display 8.
To change the setting:
1 By pressing the button 3, you can switch the
function off ‚:‹‹ or on ‚:‹‚.
2 Press START button )".
The set value is saved.
3 Close the door.
Remaining running time display
When the programme is selected, the remaining
running time of the programme is indicated on the
digital display 8.
The running time is determined during the programme
by the water temperature, the number of utensils as
well as the degree of soiling and may vary (depending
on the selected programme).
Timer programming
You can delay the start of the programme in 1 hour
steps up to 24 hours.
1 Open the door.
2 Switch on ON/OFF switch (.
3 Press the button ` + until ‹‚ is flaching in the
timer programming display X.
4 Press + or – button until the ` displayed time
corresponds with your requirements.
5 Press START button )", timer programming is
activated.
6 To delete timer programming `, press
the + or – button until ‹‹ is indicated on the
digital display X.
You can change your programme selection at any
time until the programme starts.
7 Close the door.
End of programme
The programme has ended when the value ‹:‹‹ is
indicated on the numerical display 8.
The end of the programme is also indicated by an
acoustic signal. This function can be changed as
follows:
1 Open the door.
2 Switch on ON/OFF switch (.
3 Hold down programme button # and press
START button )" until •:‹.... is indicated on the
digital display.
4 Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factory setting •:‹….
5 Press programme button # until the factory set
value ›:‹ƒ is indicated on the digital display 8.
To change the setting,
1 Press programme button 3. Each time the
button is pressed, the set value increases by one
level; when the value of ›:‹„ has been reached,
the display jumps back to ›:‹‹ (off).
2 Press START button )", the set value is saved.
3 Close the door.
